欢迎登录材料期刊网

材料期刊网

高级检索

在国内外有关理论燃烧温度研究的基础上,结合理论燃烧温度实时计算的特点和要求,对计算中的关键量进一步修正。采用埃特金迭代法求解各条件下的理论燃烧温度值。结果表明,若不考虑其他因素,煤粉燃烧率对理论燃烧温度的影响因煤粉种类而异。通常烟煤的理论燃烧温度随燃烧率的增加而降低,相同燃烧率下烟煤的理论燃烧温度明显低于无烟煤。随着混合煤粉燃烧率的增加,理论燃烧温度稍有降低。随着喷煤量提高,烟煤的理论燃烧温度降低幅度大于无烟煤。在其他条件相同时,随着烟煤配比的增加,理论燃烧温度呈降低趋势。随着煤粉和焦炭的灰分含量的增加,理论燃烧温度呈降低趋势。

On the basis of the study on the theoretical flame temperature at home and abroad,combined with the characteristics and requirements of real-time calculation,the key parameters for calculating the theoretical flame temperature(TFT) were further amended.The value of the TFT under various conditions was solved by using Aitken iterative method.The results show that the effect of coal burnout on the theoretical flame temperature varies by coal types without taking other factors into consideration;the TFT of bituminous coal usually decreases with the increasing of the burnout.The TFT of bituminous coal is significantly lower than the counterpart of anthracite at the same burnout.With increasing the burnout of mixed coal,the TFT is slightly lower.With increasing pulverized coal injection rate,the decrement of TFT of bituminous coal exceeds the counterpart of anthracite.At the same other conditions,with increasing the bituminous coal ratio,the TFT is decreasing.As coal or coke ash content increases,the theoretical flame temperature is decreasing.

参考文献

[1] 徐辉,邹宗树.对理论燃烧温度计算的一点认识[J].炼铁,2008(02):54-55.
[2] 王筱留.高炉生产知识问答[M].北京:冶金工业出版社,2006
[3] 赵晓明,张建良,卢虎生.控制适宜理论燃烧温度保证富氧喷煤高炉良好炉缸热状态[J].包头钢铁学院学报,2003(02):124-126,145.
[4] 王颖生;李伟广;竺维春.高炉理论燃烧温度计算及分析[J].首钢科技,2001(03):1.
[5] 徐书钢;田辉.风口前理论燃烧温度的在线计算[J].本钢技术,2000(04):7.
[6] 那树人.炼铁计算[M].北京:冶金工业出版社,2005
[7] 张寿荣,毕学工.关于大量喷煤高炉的某些理论问题的思考[J].钢铁,2004(02):8-13,42.
[8] 张二华,吴铿,万鹏,韦少华,李康,杨森.SiO2还原对高炉风口前理论燃烧温度的影响[J].北京科技大学学报,2010(11):1406-1411.
[9] 吴胜利,余晓波,陈辉,徐健,王筱留.高炉理论燃烧温度的计算[J].北京科技大学学报,2008(12):1432-1438.
[10] 张建良,杨天钧,高征铠,高斌,张宗旺,王丽华.高炉喷煤过程煤粉分解热确定的新方法[J].北京科技大学学报,2001(04):308-310.
[11] K. S. Abdel Halim;V. N. Andronov;M. I. Nasr .Blast furnace operation with natural gas injection and minimum theoretical flame temperature[J].Ironmaking & Steelmaking: Products and applications,2009(1):12-18.
[12] 吴胜利,陈辉,余晓波,徐健,王筱留.高炉理论燃烧温度计算的研究[J].钢铁,2008(09):16-19.
[13] Guo Baoyu;Zulli Paul;Rogers Harold et al.Three-Dimen- sional Simulation of Flow and Combustion for Pulverised Coal Iniection[J].ISIJ International,2005,45(09):1272.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%