为了研究析出相对深冲DP钢织构的影响机制,采用Thermo-calc热力学软件计算DP钢的平衡析出相,并利用SEM、IEM与XRD等手段分析了两种不同成分的DP钢组织性能与织构演变.研究表明:试验钢的主要析出相为MC_SHP、M7C3、MnS和AlN;与低Mo钢相比,高Mo钢的奥氏体区被缩小,且MoC的析出温度更高,铁素体晶内与沿晶界形成了大量的纳米级MoC析出;860℃退火后,高Mo钢中形成了约3％的均匀弥散分布的马氏体,抗拉强度达到445 MPa,r值为1.5,而低Mo钢发生了贝氏体相变,各项力学性能明显降低;两种试验钢的热轧板织构较弱,冷轧后{223} <110>取向密度稳定增加,退火后均形成了强烈的γ纤维织构,而低Mo钢中{001} <110>织构是导致其r值偏低的主要原因.
参考文献
| [1] | 康永林,陈贵江,朱国明,宋仁伯.新一代汽车用先进高强钢的成形与应用[J].钢铁,2010(08):1-6,19. |
| [2] | 马鸣图;吴宝榕.双相钢-物理和力学冶金[M].北京:冶金工业出版社,2009 |
| [3] | 乔立峰,刘振宇,王国栋,张红梅.退火时间对含铌高强细晶IF钢组织性能的影响[J].北京科技大学学报,2010(08):998-1003. |
| [4] | 宋维锡.金属学[M].北京:冶金工业出版社,2008 |
| [5] | D.Bandyopadhyay;B.Haldar .The Ti-Mo-C (Titanium-Molybdenum-Carbon) system[J].Journal of Phase Equilibria,1999(3):332-336. |
| [6] | 张学辉,李永强,庞海轮,朱国辉,毛卫民,张先贵.Nb和Cr对冷轧低碳低硅双相钢组织性能的影响[J].材料热处理学报,2009(01):96-99,103. |
| [7] | Lee W.B.;Hong S.G. .INFLUENCE OF Mo ON PRECIPITATION HARDENING IN HOT ROLLED HSLA STEELS CONTAINING Nb[J].Scripta materialia,2000(4):319-324. |
| [8] | HU H .Studies on the development of high-strength dual-phase steel sheets with high rm Values[J].Metallurgical Transactions A,1982,13A:1257-1262. |
| [9] | V. COLLA;M. DE SANCTIS;A. DIMATTEO .Strain Hardening Behavior of Dual-Phase Steels[J].Metallurgical and Materials Transactions, A. Physical Metallurgy and Materials Science,2009(11):2557-2567. |
| [10] | ASENSIOA J;ROMANOA G;MARTINEZ V J et al.Ferrite steels optimization of hot-rolled textures through cold rolling and annealing[J].Materials Characterization,2001,47:119-127. |
| [11] | RAY R K;JONAS J J;BUTRON M P et al.Transformation textures in steels[J].ISIJ International,1994,34(12):927-942. |
| [12] | INAGAKI H .Fundamental aspect of texture formation in low carbon steel[J].ISIJ International,1994,4:313-321. |
| [13] | J.-Y. Kang;B. Bacroix;H. Regie .Effect of deformation mode and grain orientation on misorientation development in a body-centered cubic steel[J].Acta materialia,2007(15):4935-4946. |
| [14] | 杨平,高鹏,孙祖庆.低碳钢压缩时的微观形变不均匀性[J].材料科学与工艺,2005(06):655-658. |
| [15] | 吕庆功,陈光南,周家琮,唐历.深冲钢板的主要织构对塑性应变比的影响[J].钢铁研究,2000(05):40-43. |
| [16] | Kitahara H;Ueji R;Tsuji N;Minamino Y .Crystallographic features of lath martensite in low-carbon steel[J].Acta materialia,2006(5):1279-1288. |
| [17] | KLINKENBERG C;RAABE D;LUCKE K .Influence of intercritical annealing on the texture formation in low-carbon steel strips[J].STEEL RESEARCH,1993,64(05):262-266. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%