Two commercial grade aluminum based immiscible bearing alloys were spray-deposited using convergent-divergent type of nozzle. The processing parameters for spray-deposition were adjusted in such a way that most of the droplets arrived on the deposition substrate in either liquid or semi-liquid state. The microstructural features of spray-formed and as-cast alloys are compared. In spray-formed alloys equiaxed grains were observed. The cell boundaries and intercellular regions were observed to be decorated with sub-micron sized particles whereas in normal casting the second phase was observed to be segregated along grain boundaries. The morphology and distribution of second phase were observed to have similarity with those in over-spread and atomized powders produced under similar processing conditions. The microstructural features observed with variation in spray conditions are discussed in detail.
参考文献
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%