对超声波参数和换热器参数对超声波空化效应影响的研究，能够找出最佳的超声波参数使其防除垢效果更好。本文利用数值计算方法研究了超声波功率、频率和换热器内介质温度以及换热管的型式对超声空化的影响。结果表明，随着超声波功率的增大，水中汽含率也增大，而且变化也相对激烈；随着频率的增加汽含率先增大后降低，20kHz为最佳频率；介质温度越高，空化效应越强烈；管径波动较多的波纹管更有利于空化效应的产生和发展。
Researching the influences that ultrasonic parameters and heat exchanger parameters may bring about in ultrasonic cavitation, we can find out the most proper ultrasonic parameters that make the effect of cleaning dirt better. The thesis study the influences that ultrasonic power, frequency, medium temperature in heat exchangers and the type of heat exchangers tube may bring about in ultrasonic cavitation through numerical calculation. The result show that with the ultrasonic power＇s increase, the gas rate in water will increase, and the change will be relatively sharp; with the frequency＇s increase, the gas rate in water will increase soon and decrease later, the most proper frequency is 20 kHz, the higher medium temperature, the stronger ultrasonic cavitation, if bellows has more changes in diameter, the development of ultrasonic cavitation will be more easy.
参考文献
| [1] | 李万鹏,王钧.应用超声波技术进行热交换设备在线防垢[J].世界有色金属,2002(06):36-38,48. |
| [2] | 李争彩,林书玉.超声空化影响因素的数值模拟研究[J].陕西师范大学学报（自然科学版）,2008(01):38-42. |
| [3] | 孙冰 .基于FLUENT软件的超声空化数值模拟[D].大连海事大学,2008. |
| [4] | 蒙海英 .基于MATLAB的超声波声场模拟及可视化研究[D].大连理工大学,2008. |
| [5] | 王萍辉.超声空化影响因素[J].河北理工学院学报,2003(04):154-161. |
| [6] | 余涛,傅俊萍.超声波在线防垢、除垢与强化传热的实验研究[J].湖南冶金职业技术学院学报,2005(03):327-329. |
| [7] | 李林 .超声场下空化气泡运动的数值模拟和超声强化传质研究[D].四川大学,2006. |
| [8] | 孙晓清 .超声波防垢的流动液体运行参数和管道参数实验研究[D].陕西师范大学,2007. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%