通过制备两种不同尺寸单晶试样的凝固试验,研究了试样尺寸对DD3单晶高温合金组织的影响。结果表明,在相同的凝固工艺条件下,试样尺寸增大,合金的一次枝晶间距和二次枝晶间距变大,合金元素的偏析程度稍有增加,枝晶干和枝晶间的铸态γ′相尺寸稍有增大,显微疏松无明显改变,共晶的尺寸和含量增加;经相同的热处理工艺处理后,试样尺寸增大,合金枝晶干和枝晶间的γ′相尺寸稍有增大。
The effects of sample size on the microstructure of DD3 single crystal superalloy were investigated.The results show that with the increasing of the sample size,the primary and secondary dendrite arm spacing increase,the extent of elements segregation is a little increase,the size of γ′ phase particles of dendritic core and indendritic slightly increases,the size and volume fraction of γ/γ′ eutectic increases,microporosity has no obvious change.After same heat treatment,the size of γ′ phase particles of dendritic core and indendritic slightly increases with the increasing of the sample size.
参考文献
| [1] | Caron P;Khan T.Evolution of Ni-Base Superalloys for Single Crystal Gas Turbine Blade[J].Aerospace Science and Technology,1999(03):513. |
| [2] | LIU L;HUANG T W;ZHANG J et al.Microstructure and Stress Rupture Properties of Single Crystal Superalloy CMSX- 2 Under High Thermal Gradient Directional Solidification[J].Materials Letters,2007,61:227. |
| [3] | Lamm M;Singer R F .The Effect of Casting Conditions on the High-Cycle Fatigue Properties of the Single Crystal Nickel- Base Superalloy[J].Metallugieal and Materials Transactions,2007,38A:1177. |
| [4] | Wilson, BC;Cutler, ER;Fuchs, GE .Effect of solidification parameters on the microstructures and properties of CMSX-10[J].Materials Science and Engineering. A, Structural Materials: Properties, Microstructure and Processing,2008(1/2):356-364. |
| [5] | ZHANG W M;DU W;FU H Z .Effect of Solidification Con- dition on Mierostrueture and Mechanical Properties of Single Crystal Superalloy[J].Journal of Materials Science and Technology,2001,17(01):89. |
| [6] | LIU C B;SHEN J;ZHANG J et al.Effect of Withdrawal Rates on Microstructure and Creep Strength of a Single Crystal Superalloy Processed by LMC[J].J Mater Sei Technol,2010,26(04):306. |
| [7] | 赵乃仁,金涛,孙晓峰,管恒荣,杨洪才,胡壮麒.抽拉速率对SRR99单晶高温合金组织和性能的影响[J].材料研究学报,2008(01):46-52. |
| [8] | 郑启,候桂臣,孙晓峰,金涛,管恒荣,胡壮麒.单晶凝固组织的样品尺寸效应[J].材料工程,2002(03):24-27. |
| [9] | ZHANG Weiguo,LIU Lin,ZHAO Xinbao,HUANG Taiwen,YU Zhuhuan,QU Min,FU Hengzhi.Effect of cooling rates on dendrite spacings of directionally solidified DZ125 alloy under high thermal gradient[J].稀有金属（英文版）,2009(06):633-638. |
| [10] | 顾林喻.高温合金定向凝固枝晶间距与冷却速率的关系[J].西安工业学院学报,1999(02):147-150. |
| [11] | 杜炜;魏朋义;李建国 等.中速生长条件下单晶高温合金组织及偏析研究[J].金属学报,1998,34(04):356. |
| [12] | DU W;LI J G;FU H Z .Solidification and Microstructure Behaviors of Nickel-Base Single Crystal Superalloy Solidified at Medium Cooling Rate[J].Trans Nonferrous Met Soc Chi na,1998,8(01):83. |
| [13] | Lecomte-Becker J.Relations Between Chemistry, Solidifica- tion Behavior, Microstructure and Microporosity in Nickel- Base Superalloy[A].Warrendale,PA:TMS,1988:371. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%