综述了异种材料累积叠轧技术,介绍了累积叠轧的工艺原理及异种材料累积叠轧试样的宏观结构和力学性能研究进展,分析了层状复合材料累积叠轧工艺的复合机理和强化机制,最后展望了异种材料累积叠轧工艺的应用和发展并对进一步的研究提出了建议.
参考文献
| [1] | Valiev RZ.;Alexandrov IV.;Islamgaliev RK. .Bulk nanostructured materials from severe plastic deformation [Review][J].Progress in materials science,2000(2):103-189. |
| [2] | Yoshinori iwahasgi .The process of grain refinement in equal-channel angular pressing[J].Acta materialia,1998(9):3317-3331. |
| [3] | Valiev R Z .Structure and mechanical properties of ultrafinegrained metals[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,1997,234-236:59. |
| [4] | 约翰;伯克;威斯.超细晶粒金属[M].北京:国防工业出版社,1982:1. |
| [5] | Mishra R S;Valiev R Z;Mukherjee A K .The observation of tensile superplasticity in nanocrystalline material[J].Nano-Structured Materials,1997,9(1-8):473. |
| [6] | A. Azushima;R. Kopp;A. Korhonen;D. Y. Yang;F. Micari;G. D. Lahoti;P. Groche;J. Yanagimoto;N. Tsuji;A. Rosochowski;A. Yanagida .Severe plastic deformation (SPD) processes for metals[J].CIRP Annals,2008(2):716-735. |
| [7] | Saito Y.;Tsuji N.;Sakai T.;Utsunomiya H. .Novel ultra-high straining process for bulk materials - Development of the accumulative roll-bonding (ARB) process[J].Acta materialia,1999(2):579-583. |
| [8] | Y. Saito;N. Tsuji;H. Utsunomiya;T. Sakai;R. G. Hong .Ultra-fine grained bulk aluminum produced by accumulative roll-bonding (ARB) process[J].Scripta materialia,1998(9):1221-1227. |
| [9] | Tsuji N;Shiotsuki K;Utsunomiya H et al.Low temperature superplasticity of ultra-fine grained 5083 aluminum alloy produced by accumulative roll-bonding[J].Materials Science Forum,1999,304-306:73. |
| [10] | 王耀奇,侯红亮,李志强.纯铝累积叠轧焊高温力学性能与显微组织研究[J].塑性工程学报,2006(05):45-47,64. |
| [11] | Lee SH.;Saito Y.;Sakai T.;Utsunomiya H. .Microstructures and mechanical properties of 6061 aluminum alloy processed by accumulative roll-bonding[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2002(1/2):228-235. |
| [12] | N.Tsuji;Y.Saito;H.Utsunomiya;S.Tanigawa .ULTRA-FINE GRAINED BULK STEEL PRODUCED BY ACCUMULATIVE ROLL-BONDING(ARB)PROCESS[J].Scripta materialia,1999(7):795-800. |
| [13] | 许荣昌,唐荻,任学平,温永红,王小红,王耀奇.累积叠轧焊工艺改善普碳钢材料性能特征[J].北京科技大学学报,2005(04):448-452. |
| [14] | Del Valle J A;Pérez-Prado M T;Ruano O A .Accumulative roll bonding of a Mg-based AZ61 alloy[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2005,410-411:353. |
| [15] | 陈维平,杨冬雨,詹美燕.累积叠轧焊温度和循环道次对AZ31镁合金组织和性能的影响[J].特种铸造及有色合金,2008(05):338-341. |
| [16] | Sayed Abdollah Hosseini;Habib Danesh Manesh .High-strength, high-conductivity ultra-fine grains commercial pure copper produced by ARB process[J].Materials & Design,2009(8):2911-2918. |
| [17] | 陈彬,林栋樑,曾小勤,卢晨.累积轧合法的研究现状及存在的问题[J].机械工程材料,2005(08):4-5,51. |
| [18] | 詹美燕,李元元,陈维平.累积叠轧技术的研究现状与展望[J].中国有色金属学报,2007(06):841-851. |
| [19] | 侯红亮,王耀奇,赵祖德.累积叠轧连接技术及其研究进展[J].航空制造技术,2007(08):30-34. |
| [20] | Mozaffari A;Manesh H D;Janghorban K .Evaluation of mechanical properties and structure of multilayered A1/Ni composites produced by accumulative roll bonding (ARB)process[J].Journal of Alloys and Compounds,2010,489(01):103. |
| [21] | Investigation of structure and mechanical properties of multi-layered Al/Cu composite produced by accumulative roll bonding (ARB) process[J].Composites science and technology,2008(9):p.2003. |
| [22] | Ghalandari, L;Moshksar, MM .High-strength and high-conductive Cu/Ag multilayer produced by ARB[J].Journal of Alloys and Compounds: An Interdisciplinary Journal of Materials Science and Solid-state Chemistry and Physics,2010(1):172-178. |
| [23] | Wu K;Chang H;Maawad E et al.Microstructure and mechanical properties of the Mg/Al laminated composite fabricated by accumulative roll bonding (ARB)[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2010,527(13-14):3073. |
| [24] | Sun Y F;Tsuji N;Fujii H et al.Cu/Zr nanoscaled multistacks fabricated by accumulative roll bonding[J].Journal of Alloys and Compounds,2010,504:S443. |
| [25] | Dengke Yang;Pavel Cizek;Peter Hodgson .Ultrafine equiaxed-grain Ti/Al composite produced by accumulative roll bonding[J].Scripta materialia,2010(5):321-324. |
| [26] | 刘华赛,张滨,张广平.累积叠轧焊制备Al/AZ31多层复合材料及其强度[J].稀有金属,2009(02):285-289. |
| [27] | Alizadeh, M. .Comparison of nanostructured Al/B_4C composite produced by ARB and Al/B_4C composite produced by RRB process[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2010(2):578-582. |
| [28] | Hsieh PJ;Huang JC;Hung YP;Chou SI;Jang JSC .Characterization on nanocrystallization and amorphization evolution in Zr-X alloys during ARB process[J].Materials Chemistry and Physics,2004(2/3):364-376. |
| [29] | Movchan B A;Lemkey F D .Mechanical properties of finecrystalline two-phase materials[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,1997,224(1-2):36. |
| [30] | Menzel S;Strehle S;Wendrock H;Wetzig K .Effect of Ag-alloying addition on the stress-temperature behavior of electroplated copper thin films[J].Applied Surface Science: A Journal Devoted to the Properties of Interfaces in Relation to the Synthesis and Behaviour of Materials,2005(1):211-214. |
| [31] | J. McKeown;A. Misra;H. Kung .Microstructures and strength of nanoscale Cu-Ag multilayers[J].Scripta materialia,2002(8):593-598. |
| [32] | Srivastava AK;Yu-Zhang K;Kilian L;Frigerio JM;Rivory J .Interfacial diffusion effect on phase transitions in Al/Mn multilayered thin films[J].Journal of Materials Science,2007(1):185-190. |
| [33] | Shingu PH.;Otsuki A.;Daigo I.;Ishihara KN. .Nano-scaled multi-layered bulk materials manufactured by repeated pressing and rolling in the Cu-Fe system[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2001(0):399-402. |
| [34] | Yasuna K;Terauchi M;Otsuki A et al.Formation of nanoscale Fe/Ag multi-layer by repeated press rolling and its layer thickness dependence of magnetoresistance[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2000,285(1-2):412. |
| [35] | Sieber H;Wilde G;Perepezko J H .Thermally activated amorphous phase formation in cold-rolled multi-layers of AlNi,Al-Ta,Al-Fe and Zr-Cu[J].Journal of Non-Crystalline Solids,1999,250-252(02):611. |
| [36] | A.Sagel;H.Sieber;H.-J. Fecht .Synthesis of an amorphous Zr-Al-Ni-Cu alloy with large supercooled liquid region by cold- rolling of elemental foils[J].Acta materialia,1998(12):4233-4241. |
| [37] | Nicholas M G;Milner D R .Pressure welding by rolling at elevated temperatures[J].British Welding Journal,1961,8(08):375. |
| [38] | Tsuji N;Saito Y;Utsunomiya H.Formation of ultrafine grains in ferrous and aluminum alloys highly strained by the accumulative roll-bonding(ARB)[A].,1999 |
| [39] | Franklin D .Theory of plastic instability in thin-wall tubes[J].Acta Metallurgica,1972,20(06):839. |
| [40] | Dinga Y;Jianga J;Shan A .Plastic instability and strain rate sensitivity of ultrafine-grained iron[J].Journal of Alloys and Compounds,2009,487(1-2):517. |
| [41] | Mashreghi A;Ghalandari L;Reihanian M et al.Processing,strength and ductility of bulk nanostructured metals produced by sever plastic deformation:An overview[J].Materials Science Forum,2010,633-634:131. |
| [42] | Kim H W;Kang S B;Tsuji N et al.Elongation increase in ultra-fine grained A1-Fe-Si alloy sheets[J].Acta Materialia,2005,53(06):1737. |
| [43] | Ding HS;Lee JM;Lee BR;Kang SB;Nam TH .Effects of subsequent heat treatment on the shape memory behaviors of a Ti/Ni sheet fabricated by bonding and cold rolling of Ti/Ni multilayers[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2007(1/2):265-270. |
| [44] | Min G;Lee J M;Kang S B et al.Evolution of microstructure for multi-layered Al/Ni composites by accumulative roll bonding process[J].Materials Letters,2006,60(27):3255. |
| [45] | Hansen N;Huang X;Hughes D A .Microstructural evolution and hardening parameters[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2001,317(1-2):3. |
| [46] | Sakai T;Saito Y;Hirano K et al.Deformation and recrystallization behavior of low-carbon steel in high-speed hot rolling[[J].Trans Iron Steel Institute Japan,1988,28(12):1028. |
| [47] | 荆日福.适用于住宅的新型铜铝散热器[J].山西建筑,2003(04):143-144. |
| [48] | XU Gao-lei,张迎晖,LIN Mu-fa,邓江文.铜铝复合材料的研究与应用[J].有色金属加工,2008(04):6-8,25. |
| [49] | XU Rongchang,TANG Di,REN Xueping,WANG Xiaohong,WEN Yonghong.Improvement of the matrix and the interface quality of a Cu/Al composite by the MARB process[J].稀有金属（英文版）,2007(03):230-235. |
| [50] | 何春雨,许荣昌,任学平,李红.钛/钢复合板累积叠轧焊复合工艺的试验研究[J].上海金属,2006(03):28-31. |
| [51] | 董成文;李艳芳;任学平 .TAl/Q235钢复合板累积叠轧焊界面特性[J].北京科技大学学报（自然科学版）,2008,30(03):249. |
| [52] | A. Kolahi;A. Akbarzadeh;M. R. Barnett .Electron back scattered diffraction (EBSD) characterization of warm rolled and accumulative roll bonding (ARB) processed ferrite[J].Journal of Materials Processing Technology,2009(3):1436-1444. |
| [53] | 于朝清,徐孝德,何青云,黄文权,王丽琼.超薄连续复合带的研制[J].电工材料,2002(03):16-20. |
| [54] | 林大超;史庆南 .双金属轧制复合技术及其研究的进展[J].云南冶金,1998,28(05):32. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%