采用轧制结合Gleeble-3500热模拟试验机模拟连续退火,研究了以低温卷取和中间退火为主要特征的改进工艺对冷轧TRIP钢组织和力学性能的影响。结果表明,低温卷取有利组织细化,中间退火工艺在降低冷轧抗力的同时有利提高钢在最终退火后的残留奥氏体量。等温淬火温度不同时,贝氏体形态与残余奥氏体量均不同,在400～420℃时可获得较高体积分数的残余奥氏体。改进工艺配合适当热处理工艺参数（420℃×5 min）条件下,实验冷轧TRIP钢的抗拉强度达到1030 MPa,总伸长率保持20%,综合性能优良。
Simulation test of rolling and continuous annealing of a C-Mn-Si TRIP steel was carried out on a Gleeble-3500 thermal simulation tester.The effect of the process on microstructure and mechanical properties of the cold rolled TRIP steel was examined.The process was mainly characterized by coiling at lower temperature and intermediate annealing.The results show that coiling at low temperature is favourable to structure refinement and the intermediate annealing decreases the cold rolling resistance and enhances the amount of final retained austenite.Different morphology of bainite and different volume fraction of retained austenite in the steel austempered at different temperatures are observed.The higher amount of retained austenite is obtained for the steel austempered at 400~420 ℃.Under the condition of the improved process with appropriate heat treatment parameters（austempered at 420 ℃ for 6 min）,the experimental cold-rolled TRIP steel exhibits excellent performance with tensile strength of 1030 MPa and total elongation of 20%.
参考文献
| [1] | Zackay V F;Parker E R;Fahr D et al.The enhancement of ductility on high strength steels[J].Trans of ASM,1967,60(02):252-259. |
| [2] | 康永林,王波.TRIP钢板的组织、性能与工艺控制[J].钢铁研究学报,1999(03):62-66. |
| [3] | 刘建勋,李壮,吴迪,迟伟凡.新一代热轧TRIP钢的研究[J].东北大学学报（自然科学版）,2006(04):418-421. |
| [4] | De Cooman BC .Structure-properties relationship in TRIP steels containing carbide-free bainite[J].Current opinion in solid state & materials science,2004(3/4):285-303. |
| [5] | 熊自柳,蔡庆伍,江海涛,唐荻,张梅.超高强TRIP钢的热处理工艺对组织与力学性能的影响[J].金属热处理,2009(09):83-87. |
| [6] | 邝霜,康永林,于浩,窦婷婷,尹显东,刘仁东.600MPa级冷轧双相钢的试制与研究[J].材料工程,2006(z1):329-333. |
| [7] | 朱铮.汽车用高强度钢板的开发应用和发展前景[J].钢铁,2000(11):66-70,14. |
| [8] | 刘宗昌;任慧平;宋义全.金属固态相变教程[M].北京:冶金工业出版社,2003 |
| [9] | 李壮,张平礼,吴迪.低碳硅锰钢亚温等温淬火热处理工艺研究[J].航空制造技术,2004(08):90-92,95. |
| [10] | 江海涛,唐荻,刘强,刘仁东,严玲.TRIP钢中残余奥氏体及其稳定性的研究[J].钢铁,2007(08):60-63,82. |
| [11] | Sugimoto K;Misu M .Effect of second phase morphology on retained austenite morphology and tensile properties in a TRIP-aided dual phase steel sheet[J].ISIJ ImemationaI,1993,33(07):775-782. |
| [12] | 宋洪伟.微米、亚微米与纳米超细晶粒钢的研究进展[J].世界科技研究与发展,2002(06):31-35. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%