针对多孔硅在MEMS中作为牺牲层和绝热层的应用,主要研究了电化学腐蚀法制备多孔硅的实验条件与多孔硅深度及其孔隙率间的关系,实验发现电化学腐蚀法制备多孔硅的腐蚀速率在腐蚀前期阶段基本是一定值(电流密度为80mA/cm2时为1.3μm/min,电流密度为40 mA/cm2时为0.4μm/min),但到腐蚀后期阶段随着孔深的增加有所下降.同时发现对于不同的腐蚀电流密度,多孔硅的孔隙率都有随腐蚀时间的延长先增加后降低的趋势,用Beale模型可以很好的解释这一现象.最后,针对多孔硅在制备后易发生龟裂的现象,用拉曼光谱分析了多孔硅的内部应力情况,结果表明随多孔硅孔隙率的上升其内部残余应力有增加的趋势.
参考文献
| [1] | Herino R;Bomchil G .Porosity and Pore Size Distributions of Porous Silicon Layers[J].Journal of the Electrochemical Society,1987,134(08):1994-2000. |
| [2] | Ingrid De Wolf;Chen Jian;W.Merlijn van Spengen .The investigation of microsystems using Raman spectroscopy[J].Optics and Lasers in Engineering,2001(2):213-223. |
| [3] | Ingrid De Wolf.Topical review:Micro-Raman spectroscopy to study local mechanical stress in silicon integrated circuits[J].Semiconductor Science and Technology,1996(11):139-154. |
| [4] | Ingrid De Wolf.Stress measurements in Si microelectronics devices using Raman spectroscopy[J].Journal of Raman Spectroscopy,1999(30):877-883. |
| [5] | S. Manotas;F. Agullo-Rueda;J. D. Moreno .Lattice-mismatch induced-stress in porous silicon films[J].Thin Solid Films: An International Journal on the Science and Technology of Thin and Thick Films,2001(1/2):306-309. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%