The effect of Bagasse ash (BAp) particle reinforcement on the wear behavior of Al-Cu-Mg alloy has been studied. Bagasse ash particles were varied from 0 wt pct-10 wt pct with interval of 2 wt pct. Unlubricated pin-on disc tests were conducted to examine the wear behaviour of the aluminium alloy/Bagasse ash particulate composites. The tests were conducted at varying loads, from 5 to 20 N and sliding speeds of 1.26 m/s,2.51 m/s, 3.77 m/s and 5.02 m/s for a constant sliding distance of 5000 m. The results showed that the wear rates of the Al-Cu-Mg/BAp composites are lower than that of the matrix alloy and further decrease with increasing Bagasse ash content. Wear rate increases as the sliding speed and applied load increase. The microstructure of the worn surface revealed that a large amount of plastic deformation appeared on the surface of the unreinforced alloy. While Bagasse ash reinforced AI-Cu-Mg alloy showed worn out surface that is not smooth, and grooves, scratches and parallel lines were observed. A combination of adhesion and delamination wear was in operation.These results show that improve wear properties is achievable for the aluminium alloy by the addition of Bagasse ash particles as reinforcement material.
参考文献
| [1] | V.S. Aigbodion;S.B. Hassan .Effects of silicon carbide reinforcement on microstructure and properties of cast Al-Si-Fe/SiC particulate composites[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2007(1/2):355-360. |
| [2] | K. Ganesan;K. Rajagopal;K. Thangavel .Evaluation of bagasse ash as corrosion resisting admixture for carbon steel in concrete[J].Anti-Corrosion Methods and Materials,2007(4):230-236. |
| [3] | S. C. Lim;M. Gupta;L. Ren;J. K. M. Kwok .The tribological properties of Al-Cu/SiCp metal-matrix composites fabricated using the rheocasting technique[J].Journal of Materials Processing Technology,1999(0):591-596. |
| [4] | S.B. Hassan;V.S. Aigbodion .The study of the microstructure and interfacial reaction of Al-Cu-Mg/bagasse ash particulate composite[J].Journal of Alloys and Compounds: An Interdisciplinary Journal of Materials Science and Solid-state Chemistry and Physics,2010(1/2):571-574. |
| [5] | K. M. Shorowordi;A. S. M. A. Haseeb;J. R. Celis .Velocity effects on the wear, friction and tribochemistry of aluminum MMC sliding against phenolic brake pad[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2004(11/12):1176-1181. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%