The isothermal and non-isothermal experiments were performed to construct the continuous cooling trans formation (CCT) and temperature time transformation (TTT) diagrams of four industrial mold fluxes through visual observations in an experimental apparatus based on the single hot thermocouple technique (SHTT).The results of the CCT diagrams indicate that ① the crystallization temperature of mold fluxes lowers as the cooling rate increases,② the mold fluxes have larger critical cooling rate,higher crystallization temperature,and less onset time of crystallization when the basicity increases or the viscosity decreases,③ the influences of the melting points of the mold fluxes on their crystallization tendency are not significant.Isothermal tests show that the onset time of crystallization decreases at first,and then increases,and finally represents a"C"shape with increasing isothermal temperature.The TTT diagrams of four industrial mold fluxes were divided into two separate"C"shape regions.The crystal phase of C20A selected was analyzed by X-ray diffraction,which is cuspidine (Ca4Si2O7F2 ) over 1 100℃ and calcium silicon oxide fluoride (Ca2SiO2F2) below 1 100 ℃.When compared with the TTT diagram,the CCT diagram can provide a more realistic estimate of the critical cooling rate of the mold fluxes.Thus,both the CCT and TTT diagrams can unambiguously describe the crystallization phenomena of the mold fluxes.
参考文献
| [1] | Kenneth C. MILLS;Alistair B. FOX .The Role of Mould Fluxes in Continuous Casting―So Simple Yet So Complex[J].ISIJ International,2003(10):1479-1486. |
| [2] | Mills K C;Fox A B;Li Z .Performance and Properties of Mould Fluxes[J].Ironmaking and Steelmaking,2005,32(01):26. |
| [3] | Lee SB;Kim NJ .Kinetics of crystallization in continuously cooled BMG[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2005(1/2):153-158. |
| [4] | Yoshiaki Kashiwaya .Development of Double and Single Hot Thermocouple Technique for in Situ Observation and Measurement of Mold Slag Crystallization[J].ISIJ International,1998(4):348-356. |
| [5] | Yoshiaki Kashiwaya .An Investigation of the Crystallization of a Continuous Casting Mold Slag Using the Single Hot Thermocouple Technique[J].ISIJ International,1998(4):357-365. |
| [6] | Hng H H;Li Y;Ng S C et al.Critical Cooling Rates for Glass Formation in Zr-AI-Cu-Ni Alloys[J].Journal of Non-Crystalline Solids,1996,208:127. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%