以新型阻燃合金Ti14合金(α+Ti2Cu)为对象,研究了Ti合金在固态和半固态变形的组织演变过程,分析了温度和变形量对合金晶粒形态和晶界特征的影响,结果表明:半固态条件下未发生动态再结晶,使得晶粒粗大,温度影响了液相的析出,随着温度的升高,液相析出量增加,并集中在晶界处,使得晶界宽化,由不连续转变为连续分布;变形量改变了晶界的界面能,促使晶界发生迁移和转动,导致弯曲的晶界向其曲率中心方向移动,三叉晶的交角向120°趋近.
参考文献
| [1] | Iwashita C. H.;Wei R. P. .COARSENING OF GRAIN BOUNDARY CARBIDES IN A NICKEL-BASED TERNARY ALLOY DURING CREEP[J].Acta materialia,2000(12):3145-3156. |
| [2] | 宋余九.金属的晶界与强度[M].西安:西安交通大学出版社,1986 |
| [3] | S. Pingeval;D. Piot;C. Desrayaud .Texture and microtexture development in an Al-3Mg-Sc(Zr) alloy deformed by triaxial forging[J].Acta materialia,2006(11):3095-3105. |
| [4] | Sergiy Divinski;Jens Ribbe;Guido Schmitz .Grain boundary diffusion and segregation of Ni in Cu[J].Acta materialia,2007(10):3337-3346. |
| [5] | Mabuchi M;Iwasaki H;Higashi K .An investigation of shear deformation in a semi-solid state of a high strain rate superplastic Si3N4p/Al-Mg-Si composite[J].Acta Materials,1998,46:5335-5343. |
| [6] | Chino Y;Kobata M;Iwasaki H .An investigation of compressive deformation behavior for AZ91 Mg alloy containing a small volume of liquid[J].Acta Materialia,2003,51:3309-3318. |
| [7] | D. G. Eskin;Suyitno;L. Katgerman .Mechanical properties in the semi-solid state and hot tearing of aluminium alloys[J].Progress in materials science,2004(5):629-711. |
| [8] | Mohamed Ramadan;Mitsuharu Takita;Hiroyuki Nomura;Nader El-Bagoury .Semi-solid processing of ultrahigh-carbon steel castings[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2006(1/2):285-291. |
| [9] | ZHAO Y Q;ZHU K Y;ZHAO X M .Low coast bum resistant titanium[P].Chinese Patent,ZL 97112302.0,1997. |
| [10] | ZHAO Y Q;WU W L;MA X D .Semi-solid oxidstion and deformation behavior of Ti14 alloy[J].Matetials Science and Engineering A,2004,373:315-319. |
| [11] | ZHAO Y Q;WU W L;CHANG H .Research on microstructure and mechanical properties of a new α+Ti2 Cu alloy after semi-solid deformation[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2006,416:81-186. |
| [12] | S. Pingeval;D. Piot;C. Desrayaud .Texture and microtexture development in an Al-3Mg-Sc(Zr) alloy deformed by triaxial forging[J].Acta materialia,2006(11):3095-3105. |
| [13] | Eskin D G;Suyitno L .Katgerman mechnical properties in the semi-solid state and hot tearing od aluminium alloys[J].Progress in Materials Siance,2004,49:629-711. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%