The effect of heat input on martensite formation and impact properties of gas metal arc welded modified ferritic stainless steel (409M) sheets (as received) with thickness of 4 mm was described in detail in this work. The welded joints were prepared under three heat input conditions, i.e. 0.4, 0.5 and 0.6 kJ/mm using two different austenitic filler wires (308L and 316L) and shielding gas composition of Ar + 5% CO2. The welded joints were evaluated by microstructure and charpy impact toughness. The dependence of weld metal microstructure on heat input and filler wires were determined by dilution calculation, Creq/Nieq ratio, stacking fault energy (SFE), optical microscopy (OM) and transmission electron microscopy (TEM). It was observed that the microstructure as well as impact property of weld metal was significantly affected by the heat input and filler wire. Weld metals prepared by high heat input exhibited higher amount of martensite laths and toughness compared with those prepared by medium and low heat inputs, which was true for both the filler wires. Furthermore, 308L weld metals in general provided higher amount of martensite laths and toughness than 316L weld metals.
参考文献
| [1] | J. Talonen;P. Aspegren;H. Hanninen .Comparison of different methods to measure strain induced alpha'-martensite content in austenitic steels[J].Materials Science and Technology: MST: A publication of the Institute of Metals,2004(12):1506-1512. |
| [2] | Q.X. Dai;X.N. Cheng;Y.T. Zhao .Design of martensite transformation temperature by calculation for austenitic steels[J].Materials Characterization,2004(4/5):349-354. |
| [3] | S.S.M. Tavares;J.M. Neto;M.R. da Silva .Magnetic properties and alpha' martensite quantification in an AISI 301LN stainless steel deformed by cold rolling[J].Materials Characterization,2008(7):901-904. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%