针对高炉实际操作过程中炉料的料流宽度与档位划分不一致,无钟炉顶布料后煤气流分布波动变化大,高炉顺行困难的问题,对布料操作中料流宽度计算的不足,重点考虑了炉料的受力变化对料流宽度的影响,分析了科氏力对料流宽度的影响,提出了分段考虑科氏力来计算料流宽度,修正计算了溜槽出口水平宽度的误差,建立了无钟炉顶布料的料流宽度数学模型.通过工业现场1:10的模型试验,验证了该数学模型计算料流宽度的正确性和合理性,将料流宽度和溜槽倾角调整相一致的原则应用于2 500m~3高炉,达到了布料分布合理,气流稳定,高炉顺行的目的.
Opinion's concerning the uncoordinated principle between the burden width and burden trajectory width in process of iron-making, and it is fluctuated to the flows distribution of CO after charge of bell-less top to the instable status of blast furnace. In the mathematical model of burden width, it is emphasized the force to width of burden trajectory from a kinematic view point. Analyzing effect of Coriolis force to calculation of burden width and a deviate angle of maximum burden velocity, reducing error rate of horizontal width, raising segment calculate the width of burden trajectory. The mathematical model is established to adopt industrial model experimental on the ratio of 1 10 blast furnace, the numerical model of burden width is validated to be right and rational. After applying mathe-matical model in a 2 500 cubic meter blast furnace, in which chute angle cooperate with width burden, it is validated to burden file ration, flows stabilizing, and blast furnace smoothly working.
参考文献
| [1] | Toymaa.Blast Furnace Phenomena and Modeling[M].New York:Elesvier Applied Science Publisher Ltd,1987 |
| [2] | Pouliquen O;Delour J;Savage S B .Fingering in Granular Flows[J].Nature,1997,386(24):816. |
| [3] | 朱清天,程树森.高炉料流轨迹的数学模型[J].北京科技大学学报,2007(09):932-936. |
| [4] | Miehinorihattori;Bungollno;Akioshimomura.Development of Burden Distribution Simulation Model for Bell-Less Top in a Large Blast Furnace and Its Application[J].ISU International,1993(10):1070. |
| [5] | Radhakrishnan VR.;Ram KM. .Mathematical model for predictive control of the bell-less top charging system of a blast furnace[J].Journal of Process Control,2001(5):565-586. |
| [6] | Juan Jimenez;Javier Mochon;Jesus Sainz de Ayala .Mathematical Model of Gas Flow Distribution in a Scale Mode of a Blast Furnace Shaft[J].ISU International,2004,44(03):518. |
| [7] | 杜鹏宇,程素森.无钟高炉布料测试新技术及料面三维图像重建[C].2008年全国炼铁生产技术会议暨炼铁年会论文集,2008:1117-1122. |
| [8] | Park N S .Control of Burden Distribution of No.3 BF in Pohang Works[J].Ironmaking Proceedings,1992,51:223. |
| [9] | Lee I O;chung H Y;Bang K M et al.Burden Distribution Control for No.2 BF of Pohang Works[J].Ironmaking Proceedings,1986,45:393. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%