采用显式动力学有限元方法,对立辊孔型内倒角半径R为30、50、80、110 mm 4种情况下多道次立-平轧制过程进行了模拟.分析了立辊孔型内倒角半径对轧件切头尾量、轧件稳定段轧件边部变形程度的影响.研究发现:既定条件下,第1道次立-平轧制过程中,随内倒角半径的减小头尾不均匀区域长度减少,第2、3道次立-平轧制过程中,随内倒角半径的增加,头尾不均匀变形区域长度道次增加量减少;对比采用R为30 mm的孔型立辊和R为110 mm的孔型立辊轧后轧件的头尾不均匀长度,前者比后者少5.03%;轧件稳定段轧件变形程度随着孔型立辊内倒角半径的增加而减少.
参考文献
| [1] | Okado M;Ariizumi T;Noma Y et al.Width Behavior of Head and Tail of Slabs at Edge Rolling in Hot Strip Mills[J].Journal of the Iron & Steel Institute of Japan,1981,67(15):2516-2525. |
| [2] | Nikaido H;Naoi T;Shibata K et al.Numerical Simulation of Width Spread of Dog-Bone Slab in Non-steady Horizontal Rolling[J].Journal of the Japan Society for Technology of Plasticity,1984,25(277):129-135. |
| [3] | Chung W K;Choi S K;Thomson P F .Three Dimensional Simulation of the Edge Rolling Process by the Explicit FiniteElement Method[J].Journal of Materials Processing Technology,1993,38:85-102. |
| [4] | Xiong Shangwu;Liu Xianghua;Wang Guodong;Zhang Qiang .A three-dimensional finite element simulation of the vertical-horizontal rolling process in the width reduction of slab[J].Journal of Materials Processing Technology,2000(1/3):146-151. |
| [5] | XIONG Shang-wu;LIU Xiang-hua;WANG Guo-dong et al.Simulation of Vertical-Horizontal Rolling Process During Width Reduction by Full Three-Dimensional Rigid-Plastic Finite Element Method[J].Journal of Materials Engineering and Performance,1997,6(06):757-765. |
| [6] | 赵宪明,王国栋,朴海斗,崔承甲.立辊形状对粗轧板坯侧弯的影响[J].东北大学学报(自然科学版),2002(12):1174-1176. |
| [7] | 刘慧,高彩茹,王国栋,刘相华.立辊形状对板坯断面形状的影响[J].塑性工程学报,2003(05):86-88. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%