Abrasive Wear Behavior of High Chromium Cast Iron and Hadfield Steel-- A Comparison

钢铁研究学报(英文版), 2012, 19(4): 43-50.

Abrasive Wear Behavior of High Chromium Cast Iron and Hadfield Steel-- A Comparison

^1, , ^2, , ^3,

1.Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, JohorBahru 81310, Malaysia／Institute for Materials Research, School of Process, Environmental and MaterialsEngineering, Faculty of Engineering, University of Leeds, Leeds LS29JT, UK

2.Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, JohorBahru 81310, Malaysia／Department of MaterialsEngineering, Faculty of Engineering, Semnan University, Semnan 85138-33931, Iran

3.Department of MaterialsEngineering, Faculty of Engineering, Semnan University, Semnan 85138-33931, Iran

关键词：磨粒磨损性能 , 高铬铸铁 , 高锰钢 , 磨损试验 , 摩擦系数 , 显微镜检测 , 水泥工业 , 质量损失

Abrasive Wear Behavior of High Chromium Cast Iron and Hadfield Steel-- A Comparison

Mehdi Mazar Atabaki ^1, , Sajjad Jafari ^2, , Hassan Abdollah-pour ^3,

1.Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, JohorBahru 81310, Malaysia／Institute for Materials Research, School of Process, Environmental and MaterialsEngineering, Faculty of Engineering, University of Leeds, Leeds LS29JT, UK

2.Department of Materials Engineering, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, JohorBahru 81310, Malaysia／Department of MaterialsEngineering, Faculty of Engineering, Semnan University, Semnan 85138-33931, Iran

3.Department of MaterialsEngineering, Faculty of Engineering, Semnan University, Semnan 85138-33931, Iran

Keywords： abrasive wear , Hadfield steel , high chromium , cast iron ,

Wear properties of two different crushers used for grinding raw materials of cement industry are compared using pin-on-disk wear test.The wear test was carried out with different loads on a pin.Abrasive wear behavior of two alloys was evaluated by comparing mass loss,wear resistance,microhardness and friction coefficient.The microstructure of the specimens was detected using optical microscope.The results showed that abrasive wear of high chromium cast iron is lower than that of Hadfield steel.Due to the presence of M7C3 carbides on the high chromium cast iron matrix,impact crushers exhibited higher friction coefficient

参考文献

[1]	Reich H.Optimized Crusher Selection for the Cement Industry[A].Magdeburg:[s.n.],2000:1.
[2]	Gundlach R;Janowak B J.Process Overview/Wear and Abrasion Testing[A].New York:ASME,1986:23.
[3]	Yuri N. Petrov;Valentin G. Gavriljuk;Hans Berns;Fabian Schmalt .Surface structure of stainless and Hadfield steel after impact wear[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2006(6):687-691.
[4]	Fucheng Z;Tingquan L .A Study of Friction-Induced Martensitic Transformation for Austenitic Manganese Steel[J].Wear,1997,212(02):195.
[5]	Yan W;Fang L;Sun K et al.Effect of Surface Work Hardening on Wear Behavior of Hadfield Steel[J].Materials Science and Engineering,2007,460-461A(06):542.
[6]	Dastur Y N;Leslie W C .Mechanism of Work Hardening in Hadfield Manganese Steel[J].Metallurgical and Materials Transactions,1981,12A(05):749.
[7]	A. Y. Mosbah;D. Wexler;A. Calka .Abrasive wear of WC-FeAl composites[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2005(9):1337-1341.
[8]	Tianfu j;Fucheng Z .The Work-Hardening Behavior of Medium Manganese Steel Under Impact Abrasive Wear Condition[J].Materials Letters,1997,31(05):275.
[9]	Guo-Shang Zhang;Jian-Dong Xing;Yi-Min Gao .Impact wear resistance of WC/Hadfield steel composite and its interfacial characteristics[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2006(7/8):728-734.
[10]	Da Li;Ligang Liu;Yunkun Zhang;Chunlei Ye;Xuejun Ren;Yulin Yang;Qingxiang Yang .Phase Diagram Calculation Of High Chromium Cast Irons And Influence Of Its Chemical Composition[J].Materials & design,2009(2):340-345.
[11]	Fernandez I;Belzunce F J .Wear and Oxidation Behavior of High Chromium Cast Iron[J].Materials Characterization,2008,58(06):669.
[12]	Bhushan B.Modern Tribology Handbook[M].Florida:CRC Press,2001
[13]	Schon C L;Sinatora A .Simulation of Solidification Path in High Chromium White Cast Irons for Wear Applications[J].CALPHAD-Computer Coupling of Phase Diagrams and Thermochemistry,1998,22(04):437.
[14]	Hans Berns .Comparison of wear resistant MMC and white cast iron[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2003(1/2):47-54.
[15]	Pintaude G.;Tanaka DK.;Sinatora A.;Tschiptschin AP. .The particle size effect on abrasive wear of high-chromium white cast iron mill balls[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2001(1):66-70.
[16]	Al-Rubaie K S .Equivalent Hardness Concept and Two-Body Abrasion of Iron Base Alloys[J].Wear,2000,243(1-2):92.
[17]	Abbasi M;Kheirandish S;Kharrazi Y et al.The Fracture and Plastic Deformation of Aluminum Alloyed Hadfield Steels[J].Materials Science and Engineering,2009,513-514A(07):72.
[18]	Majid Abbasi;Shahram Kheirandish;Yousef Kharrazi;Jalal Hejazi .On the comparison of the abrasive wear behavior of aluminum alloyed and standard Hadfield steels[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2010(1/2):202-207.
[19]	Remy L .The Interaction between Slip and Twinning Systems and the Influence of Twinning on the Mechanical Behavior of Face Centered Cubic Metals and Alloys[J].Metallurgical and Materials Transactions,1981,12A(03):387.
[20]	Moore M A .The Relationship Between the Abrasion Wear Resistance,Hardness and Microstructure of Ferritic Materials[J].Wear,1974,28(01):59.
[21]	Das S;Prasad B K;Jha A K et al.Three-Body Abrasive Wear of 0.98% Carbon Steel[J].Wear,1993,162-164(B4):802.
[22]	Garzino-Demo G A;Lama F L .Friction and Wear Uncoated or Si-Coated 329Stainless Steel and of Uncoated or ALN-Coated Aluminium Surfaces[J].Surface and Coatings Technology,1994,68-69(12):507.
[23]	Garzino-Demo G A;Lama F L .Friction and Wear of Metallic and Non-Metallic Surfaces[J].Surface and Coatings Technology,1995,76-77(12):487.

上一张下一张

上一张下一张

计量

下载量()
访问量()

作者相关

在本站搜索
在百度学术搜索
在万方数据库搜索
在CNKI搜索

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%