欢迎登录材料期刊网

材料期刊网

高级检索

本文采用共沉淀法制备了YAG-Al纳米复合粉体.并通过XRD、TEM详细研究了粉体组成、形貌随煅烧温度的变化.研究表明,在1300℃下煅烧可获得YAG粒径约100nm、分散均匀、无杂相的YAG-Al纳米复合粉体.粉体在1450℃可热压烧结致密,远低于文献报道的热压烧结温度1600℃.用共沉淀法制备YAG-Al纳米复合粉体具有成本低、产量高和工艺简单的优点.

YAG-Al2O3 nanocomposite powders were prepared by the co-precipitation process. The crystallize temperature and morphology of the composite powder
was intensively studied with XRD and TEM. The results indicate that above 1300℃, there is only YAG and α-Al2O3 phases existed.
YAG particles with an average size of 100 nm can be observed uniformly dispersed in α-Al2O3. Using prepared powders, nearly fully dense sintering
body can be fabricated by hot-pressing at 1450℃. The sintering temperature is far lower than 1600℃ reported by other researchers. The preparation
of YAG-Al2O3 nanocomposite powders based on the co-precipitation method has promising application with merits of low cost, high production and simple processing.

参考文献

[1] Rishi Raj. J Am.Ceram. Soc., 1993, 76: 2147--74 .
[2] 高家化, 沈志坚, 丁子上. 复 合 材 料 学 报, 1994, 11: 1-7.
[3] May Nyman, James Caruso, Toivo T. Kodas, et al. J. Am. Ceram. Soc., 1997, 80: 1231--1238.
[4] Manalert R, Rahaman M N. Journal of Materials Science 1996, 31: 3453--3458.
[5] 李强,高濂, 严 东 生(LI Qiang, et al). 无 机 材料 学 报(Journal of Inorganic Materials), 1997, 12 (4): 575--578.
[6] Masashi Inoue,hiroyuki Otsu,hiroshi kominami, et al. J. Am. Ceram. Soc., 1991, 74: 1452--1454.
[7] Gao Lian, Shen Zhijian, Miyamoto Hiroki, et al. J. Am. Ceram. Soc., in press
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%