同质冷却水口的试验研究和传热分析

钢铁研究学报, 2007, 19(8): 28-0.

同质冷却水口的试验研究和传热分析

1.1. 安徽工业大学冶金与资源学院, 安徽马鞍山 243002

1.1. School of Metallurgy and Resource, Anhui University of Technology, Ma′anshan 243002, Anhui, China

2. 2. National Engineering and Research Center for Continuous Casting Technology, Central Iron and Steel Research Institute, Beijing 100081, China

关键词：浇注;同质冷却水口;传热

Experimental Study and Heat Transfer Analysis of Same Material Cooling Nozzle

HAN Qibiao , YANG Wu , YUE Erbin , QIU Shengtao , YAN Huicheng

Keywords： casting;same material cooling nozzle;heat transfer

为实现低过热度浇注，开发了一种冷却水口。在不同长度和出口直径的条件下分别进行了多组浇钢试验和数值模拟计算。比较了2种长度、3种不同出口直径水口的浇注结果和计算结果。得到实现低过热度浇注的最佳工艺条件为水口长190 mm，出口直径为20 mm，在浇注平衡时热流为1224 MW/m2。

To achieve the low superheat casting, a kind of cooling nozzle is developed. Under the condition of different length and diameter of the outlet, many casting experiments and heat transfer calculations are carried out. After comparing the measured result with the calculated one for three levels of outlet diameter and two kinds of lengths, the best condition of realizing low superheat casting is as follows: the length of nozzle is 190 mm, its outlet diameter is 20 mm, and heat flux in balance is 1224 MW/m2.

参考文献

上一张下一张

计量

下载量()
访问量()

作者相关

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网