采用由滑轮增力机构和液压增力机构组成的二级增力机构加载的稳态热流方法,通过自制的界面接触换热系数测量装置对AZ91D镁合金/H13模具钢界面的接触换热系数进行了研究,分析了接触面载荷和温度对界面接触换热系数的影响.结果表明:当接触面载荷较低时,随载荷的增大,接触换热系数变化较为显著,在高载荷区域接触换热系数对载荷的敏感性有所下降;接触面温度越高,接触换热系数越大,在320～370℃温度范围内,界面接触换热系数随温度升高的变化不明显,越过此阶段后又随温度升高而增大.
参考文献
| [1] | Liang, SJ;Liu, ZY;Wang, ED .Simulation of extrusion process of AZ31 magnesium alloy[J].Materials Science and Engineering. A, Structural Materials: Properties, Microstructure and Processing,2009(1/2):221-224. |
| [2] | M. M. A. Rafique;J. Iqbal .Modeling and simulation of heat transfer phenomena during investment casting[J].International Journal of Heat and Mass Transfer,2009(7/8):2132-2139. |
| [3] | J. O. Aweda;M. B. Adeyemi .Experimental determination of heat transfer coefficients during squeeze casting of aluminium[J].Journal of Materials Processing Technology,2009(3):1477-1483. |
| [4] | G. Kumar;S. Hegde;K.N. Prabhu .Heat transfer and solidification behaviour of modified A357 alloy[J].Journal of Materials Processing Technology,2007(26):152-156. |
| [5] | Guo Zhi-peng;Xiong Shou-mei;Liu Bai-cheng;Mei Li;John Allison .Determination of the heat transfer coefficient at metal-die interface of high pressure die casting process of AM50 alloy[J].International Journal of Heat and Mass Transfer,2008(25/26):6032-6038. |
| [6] | 郭志鹏,熊守美,曺尚铉,崔正吉.热传导反算模型的建立及其在求解界面热流过程中的应用[J].金属学报,2007(06):607-611. |
| [7] | Zhizhong Sun;Henry Hu;Xiaoping Niu .Determination of heat transfer coefficients by extrapolation and numerical inverse methods in squeeze casting of magnesium alloy AM60[J].Journal of Materials Processing Technology,2011(8):1432-1440. |
| [8] | 张立文,朱德才,邢磊,张国梁,韦荣选.铝合金与 5CrMnMo 模具钢界面接触换热系数实验研究[J].大连理工大学学报,2009(01):60-64. |
| [9] | 朱德才,张立文,裴继斌,张国梁,韦荣选.固态塑性成形过程中界面接触换热的实验研究[J].塑性工程学报,2008(01):92-96. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%