热处理对22Cr双相不锈钢组织和点蚀性能的影响

腐蚀学报（英文）, 2009, 21(6): 599-602.

热处理对22Cr双相不锈钢组织和点蚀性能的影响

雒设计 , 王荣

西安石油大学材料科学与工程学院

西安 710065

School of Materials Science and Engineering

Xi&prime

an Shiyou University

Xi&prime

710065. 710065

基金项目: 西安石油大学科技创新基金项目(Z08037)

关键词： 22Cr双相不锈钢 , pitting corrosion , critical pitting temperature

EFFECT OF HEAT TREATMENT ON MICROSTRUCTURE AND PITTING CORROSION RESISTANCE OF 22Cr DUPLEX STAINESS STEEL

LUO She-ji , WANG Rong

Keywords： 22Cr duplex stainless steel , 点蚀 , 临界点蚀温度

研究了热处理工艺对22Cr双相不锈钢显微组织及耐点蚀性能的影响.结果表明：析出相的存在明显降低钢的耐点蚀性能.经950℃固溶处理后,材料的临界点蚀温度(CPT)由原始状态的39℃下降到23℃；在850℃时效处理,材料的临界点蚀温度(CPT) 由1050℃固溶处理后的46℃下降到23℃；随着时效时间的延长,材料的腐蚀速率急剧增加,钝化膜的稳定性下降,材料的耐蚀性能下降.在此基础上,分析了点蚀的产生机理和发展趋势.

The effect of heat treatment processes on microstructure and pitting corrosion resistance of 22Cr duplex stainless steel was studied.The results clearly showed that the intermetallic precipitates could decrease remarkably the pitting corrosion resistance of the steel being heat treated.After solution treatment at 950℃,the CPT(Critical Pitting Temperature)of the steel was declined from 39℃ for the steel as received(i.e.rolled and annealed)to 23℃.After aging at 850℃,the CPT of the steel was decreased from 46℃ for the steel solution-treated at 1050℃ to 23℃.With increasing of the aging time,the pitting corrosion rate of steel dramatically increased,the stability of the passivation film tended to become worse,and the pitting corrosion resistance decreased.Finally,the evolution tendency and mechanism of the pitting corrosion were also analyzed in this paper.

参考文献

[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]

上一张下一张

计量

下载量()
访问量()

作者相关

在本站搜索
雒设计王荣
在百度学术搜索
雒设计王荣
在万方数据库搜索
雒设计王荣
在CNKI搜索
雒设计王荣

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网