以次氯酸钠为氧化剂，对预处理过的实际电镀废水中的氨氮进行处理。研究了 NaClO 投加量、进水 pH、曝气量和搅拌方式对氨氮去除效果的影响。结果表明，曝气量和搅拌方式对氨氮去除效果的影响不大。较适宜的工艺条件为：NaClO 溶液(有效氯含量6%)50 mL/L，pH 1.50，曝气量0.40 L/min。经本工艺处理的出水氨氮符合国标要求，说明采用次氯酸钠氧化法去除电镀废水中的氨氮可行。
Sodium hypochlorite was used as an oxidant to treat the ammonia nitrogen in a pretreated electroplating wastewater. The effects of NaClO dosage, influent pH, aeration rate, and agitation method on the removal efficiency of ammonia nitrogen were studied. It is shown that aeration rate and agitation method have insignificant impact on the removal of ammonia nitrogen. The suitable process parameters are:NaClO (available chlorine 6%) 50 mL/L, pH 1.50, and aeration rate 0.40 L/min. The content of effluent ammonia nitrogen after treatment by the given process meets the national discharge standard, illustrating that using sodium hypochlorite-oxidation method to remove the ammonia nitrogen in electroplating wastewater is practicable.
参考文献
| [1] | 王文星.电镀废水处理技术研究现状及趋势[J].电镀与精饰,2011(05):42-46. |
| [2] | 陈惠国.论电镀废水治理技术发展动态[J].电镀与环保,2001(03):32-35. |
| [3] | Simple and selective extraction process for chromium (VI) in industrial wastewater[J].Journal of hazardous materials,2009(2/3):1079. |
| [4] | 李冰璟,付丹,赵伟.电镀废水中氨氮及COD的去除[J].净水技术,2011(05):115-118,154. |
| [5] | 赵璇,张蓓,李琛.电镀废水中有机污染物处理研究进展[J].云南化工,2011(02):48-53,57. |
| [6] | 杨涛,傅金祥,梁建浩.次氯酸钠预氧化处理微污染水源水的试验[J].工业用水与废水,2005(06):14-16. |
| [7] | 陆贤,刘伟京,涂勇,郭方峥,李燕,解林.次氯酸钠氧化法深度处理造纸废水试验研究[J].环境科学与技术,2011(03):90-92,133. |
| [8] | 张胜利,刘丹,曹臣.次氯酸钠氧化脱除废水中氨氮的研究[J].工业用水与废水,2009(03):23-26. |
| [9] | 顾庆龙.次氯酸钠氧化法脱除二级生化出水中氨氮的中试研究[J].环境科学与管理,2007(12):97-99,147. |
| [10] | 周相武,汪晓军,刘姣,王炜.次氯酸钠溶液的氧化性研究[J].氯碱工业,2006(08):28-30. |
| [11] | 欧阳超,尚晓,王欣泽,孔海南.曝气对电解除磷的影响研究[J].环境污染与防治,2009(07):30-33. |
| [12] | 李宇庆,马楫,马国斌,余杰,杨文婷.曝气微电解-Fenton氧化处理制药废水实验研究[J].广东化工,2011(04):153-155. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%