欢迎登录材料期刊网

材料期刊网

高级检索

采用溶胶-凝胶法和共沉淀法两种化学方法制备了氧化铝-氧化锆复合粉体,并对其进行表征:采用激光粒度分析仪测定粉体粒径及粒度分布,X射线衍射仪(XRD)进行矿物相组成分析,扫描电子显微镜(SEM)观察微观下氧化铝与氧化锆的分布情况.结果表明:溶胶-凝胶法制备的粉体相对于共沉淀法制备的粉体粒度较细,四方相氧化锆含量高,而且氧化铝和氧化锆分散较均匀.

Alumina-zirconia composite powders were prepared by two chemical methods, which were Sol-gel method and co-precipitation method, and then characterized by some equipments: size of the granularity was expressed by laser particle size analyzer, phase composition was analyzed by X-ray diffraction (XRD) and distribution of alumina and zirconia at microscopic view was observed by scanning electron microscope (SEM). The experimental results show that compared with co-precipitation method, the powder from Sol-gel method was preferable, of which the granularity was much thinner, the content of tetragonal zirconia was much higher and the distribution of alumina and zirconia was much evener.

参考文献

[1] 王新福,李红霞,杨彬.小方坯连铸用定径水口的发展趋势[J].连铸,2003(03):37-39.
[2] 刘爱国;刘振义.小方坯连铸中间包用耐火材料[J].河北冶金,1998(2-5):173-175.
[3] 钟文斌.长期浇铸用氧化锆水口[J].国外耐火材料,1992(06):19-26.
[4] Суворов С А;Туркин И А;Дедовец М А.Структура материалов на основе Al_2O_3 синтезир ованных в микроволно йпечи[J].Огнеуроры и Техническая Керамика,2004(01):2-5.
[5] B A 拉宾诺维奇;З Я 哈文;等;尹承烈.简明化学手册[M].北京:化学工业出版社,1983:547-552.
[6] Li J G;Taka Y I;Jong H L.Coprecipitation synthesis and sintering of yttrium alumina garnet (YAG) powder:the effect of precipitant[J].European Ceramic Society,2000(20):2395-2405.
[7] 武志红 .斜锆石刚玉共析体细结晶高温结构陶瓷研究开发[D].西安建筑科技大学,2005.
[8] Fischer G R;Manfredo L J;McNally R N.The Eutectic and Liqudus in the Al_2O_3-ZrO_2System[J].Journal of Materials Science,1981(12):3447-3451.
[9] Schmid F;Viechnicki D.Oriented eutectic microstructures in the system of Al_2O_3-ZrO_2[J].Journal of Materials Science,1970(05):470-473.
[10] 高振昕;王天仇;刘百宽.滑板组成与显微结构[M].北京:冶金工业出版社,2007:88-100.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%