欢迎登录材料期刊网

材料期刊网

高级检索

研究了Pd/C催化剂及其冶金废料分解和测定的问题。预先灼烧试样除去碳等杂质,再用焦硫酸钾熔解,溶解处理后分别以络合滴定法和分光光度法测定Pd。灼烧损失空白Pd/C加标回收率为99.4%~100.5%,证明试样预先灼烧未引起Pd的损失。结果表明:对于Pd含量高达xx%的样品,尽管试样组成复杂也应采用丁二肟沉淀分离滴定法进行测定;对于Pd含量<5%的样品,无论试样组成简单或复杂均应采用操作简便的光度法。

The problem of decomposing Pd/C catalyst and its metallurgical waste materials, and determining of Pd content in them were discussed. These samples were ignited previously in order to remove carbon and other impurities, and then melted further by using potassium pyrosulfate. After that, the Pd content in them were determined by using complexometric titration and spectrophotometry, respectively. For the blank samples of Pd/C which had been ignited, the recovery of standard addition was between 99.4%~100.5%. It proved that palladium in these samples was not lost by igniting previously. The research results indicated that when these samples of Pd content abovexx%, even if the composition of samples were complex, the method for determination of Pd should also select butanedione dioxime precipitation titration. But for samples of Pd content below 5%, regardless of the specimen composed of simple or complex by spectrophotometry and easy operation.

参考文献

[1] 孙锦宜;林西平.环保催化材料与应用[M].北京:化学工业出版社,2002:79-125.
[2] 王广建,丁浩,宋美芹,刘光彦.Pd/C催化剂的失活机理与回收再生研究进展[J].工业催化,2009(05):1-6.
[3] Linjun Shao;Yijun Du;Minfeng Zeng .Ethanol-promoted reductive homocoupling reactions of aryl halides catalyzed by palladium on carbon (Pd/C)[J].Applied Organometallic Chemistry,2010(5):421-425.
[4] Jagadeesh RV;Puttaswamy .Ru(III), Os(VIII), Pd(II) and Pt(IV) catalysed oxidation of glycyl-glycine by sodium N-chloro-p-toluenesulfonamide: comparative mechanistic aspects and kinetic modelling[J].Journal of Physical Organic Chemistry,2008(10):844-858.
[5] 从Pd/C废料中回收钯及制备试剂PdCl2的新工艺[J].贵金属,2012(04):9-13.
[6] 郭焕如;杨苏平;黄贤平 .微波消解ICP法测定钯碳催化剂中钯含量的方法[P].中国,ZL200710022937.9,2010-12-22.
[7] GB/T 15072.4-2008.贵金属合金化学分析方法钯、银合金中钯量的测定二甲基乙二醛肟重量法[S].北京:中国标准出版社,2008.
[8] YS/T 372.3-2006.贵金属合金元素分析方法钯量的测定丁二肟析出 EDTA 络合滴定法[S].北京:中国标准出版社,2006.
[9] GB/T 23277-2009.贵金属催化剂化学分析方法汽车尾气净化催化剂中铂、钯、铑量的测定分光光度法[S].北京:中国标准出版社,2009.
[10] 杨平平,田新娟,王辉,李波,孙宝莲.火焰原子吸收光谱法测定钯催化剂生产有机废液中钯[J].冶金分析,2010(01):58-60.
[11] 魏笑峰,蔡国辉,肖益鸿,詹瑛瑛,谢增鸿,魏可镁.火焰原子吸收光谱法测定汽车尾气催化剂中Pd的研究[J].光谱学与光谱分析,2009(12):3409-3411.
[12] 朱良.碳钯催化剂中钯含量分析方法改进[J].山西化工,2010(02):47-49,64.
[13] 黎林,雷双双,陈云霞.微波消解-电感耦合等离子体原子发射光谱法测定车用催化器中贵金属[J].冶金分析,2012(09):51-54.
[14] 朱利亚,赵忆宁,金娅秋,段颖,安中庆.金、银、铂、钯合金中钯的选择性滴定方法的研究与应用[J].贵金属,2007(02):40-44,69.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%