通过真空导入树脂模塑工艺制备了EKB1100／430LV复合材料，研究了不同工艺参数对复合材料中玻璃纤维含量及力学性能的影响。结果表明：纤维含量随真空度的增大而增加，靠近树脂注入口区域的纤维含量较低，而真空抽口附近的纤维含量最高；复合材料的拉伸强度和压缩强度也随真空度的增大而增大；充模前对预成型体实施压缩可提高纤维含量；充模过程中溢流一定的树脂可提高弯曲强度和层间剪切强度。
The EKBl100/430LV composite was prepared by vacuum assisted resin transfer molding process, and the effect of different process parameters on the glass fiber content and mechanical properties of the composite was studied. The results show that the fiber content increased with the increase of vacuum, and the fiber content closing to resin inlet was lower and that closing to vacuum vent was most high. The tensile and compressive strength of the composite increased with the increase of the vacuum. Compressing the performing body before mold filling could increase the fiber content, and overflowing some certain resin during mold filling could increase the bending strength and the interlaminar shear strength.
参考文献
| [1] | 赵渠森,赵攀峰.真空辅助成型工艺（VARI）研究[J].纤维复合材料,2002(01):42-46. |
| [2] | 祝颖丹,李新华,王继辉,高国强.高渗透介质型真空注射成型工艺的研究[J].复合材料学报,2003(04):136-140. |
| [3] | 高彦涛,李炜,罗永康.VARTM工艺中多层玻纤织物渗透规律研究与工艺优化[J].玻璃钢/复合材料,2009(06):54-57. |
| [4] | Li W;Krehl J;Gillespie JW;Heider D .Process and performance evaluation of the vacuum-assisted process[J].Journal of Composite Materials,2004(20):1803-1814. |
| [5] | D. BENDER;J. SCHUSTER;D. HEIDER .Flow rate control during vacuum-assisted resin transfer molding (VARTM) processing[J].Composites science and technology,2006(13):2265-2271. |
| [6] | 朱洪艳,吴宝昌,张东兴,李地红,陈玉勇.孔隙对碳纤维/环氧复合材料层合板层间剪切疲劳性能的影响[J].复合材料学报,2010(06):32-37. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%