采用复合熔铸一旋煅法制备了铜包Q195钢复合线材，通过拉伸试验、组织观察、电阻率测试等对其力学性能、组织形貌及电学性能进行了研究。结果表明：熔铸后铜和钢的结合面呈锯齿状，界面较清晰，组织较为粗大，无中间相形成，旋锻后组织细小；直径为2，3．4，4mm的钢芯制备的铜包钢复合棒材旋锻后制得的复合线材的抗拉强度分别是260．63，368．83，419．12MPa，电阻率分别为1．981×10^-6，1．976×10^-6，2．035×10^-6Ω·cm；旋锻后横截面上钢芯的面积比越大，其抗拉强度越接近纯钢芯的；铜包钢复合线材拉伸断口出现大量韧窝，断裂方式为典型的韧性断裂。
The copper clad Q195 steel composite wire was prepared by composite casting-swaging method, and the mechanical properties, microstructure and electric properties were studied by tensile testing, microstructure observing and resistivity testing. The results show that the serrated bonding surface between copper and steel was obtain after casting, the interface was fairly clear and microstructure was fairly large and had not intermediate phase was obtained, and the microstructure was fine after swaging. The tensile strength and resistivity of composite wires prepared by copper clad steel composite bar with steel core diameter of 2, 3. 4 and 4 mm were 260. 63,368. 83,419. 12 MPa and 1. 981× 10^-6, 1. 976 × 10^-6, 2. 035 × 10^-6Ω. cm, respectively. The tensile strength of the composite wire with a higher proportion Of steel core was closer to that of the pure steel core. The tensile fracture of the copper clad steel composite wire had amounts of dimples, and its fracture mode was typical ductile fracture.
参考文献
| [1] | 吴云忠 .包覆拉拔法铜包铝、铜包钢双金属导线的研究[D].大连海事大学,2007. |
| [2] | 赵双敬 .铜包铝线铸造-冷挤压成形工艺研究及微观组织分析[D].燕山大学,2010. |
| [3] | 王庆娟,杜忠泽,王海波.铜包钢线生产工艺的特点及现状[J].电线电缆,2002(04):15-17,27. |
| [4] | 贺飞,刘利梅,钟云,何永福,苏永庆.铜包钢线材及其生产工艺[J].表面技术,2007(05):78-80,90. |
| [5] | 费明冰.铜包钢芯线生产工艺的研究[J].电镀与精饰,1998(04):7. |
| [6] | 宋强,戴雅康,刘世程.包覆焊接法铜包钢线的结构设计和生产工艺[J].光纤与电缆及其应用技术,2003(03):44-46. |
| [7] | 何慧兰.铜包钢线的研制与应用[J].电镀与环保,2002(06):32-33. |
| [8] | 方晓英.液-固相复合工艺对铜包钢线界面质量的影响[J].机械工程材料,2006(09):54-56. |
| [9] | 吴云忠,马永庆,高洪涛,张洋,刘世永.铜包钢线材室温拉变形后的显微组织和力学性能[J].材料工程,2006(10):19-22. |
| [10] | 薛康营.轧制-拉伸与旋锻-拉伸加工工艺的对比分析研究[J].中国钼业,2000(03):38-40,43. |
| [11] | 方树铭,雷霆,张玉林,李皓,周林,张家敏.旋锻法加工低塑性有色金属异型材的应用研究[J].锻压技术,2007(05):69-72. |
| [12] | 张鸿,谢建新,王自东,王浩.连续定向凝固铜棒及其冷加工后的组织和力学性能[J].机械工程材料,2004(02):31-33. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%