Effects of chemical compositions, finish rolling temperature, isothermal temperature on runout table and coiling temperature on microstructure and mechanical properties of economical dual phase steel produced on CSP line were investigated. Experimental results showed that martensite volume fraction could be enhanced and banding microstructure could be reduced by controlling Mn, Si contents and applying proper finish rolling temperature. Optimized processing-parameters were obtained for DP580 production on CSP line of Wuhan Iron and Steel (group) Co (WISCO) in China. Optimal microstructure and mechanical properties could be achieved when the strip was finished rolling at the range of 790 to 830 ℃, isothermally holding at 680 to 740 ℃ and coiling below 250 ℃.
参考文献
| [1] | |
| [2] | G. Buzzichelli and E.anelli, Present status and perspectives of European research in the field of advanced structural steels[J],ISIJ,2002,42(12):1354-1363. [2] A.P.Coldren and G.Tither: J.Met.,30(1978),No.4,6. [3] T. Waterschoot, K. Verbeken,B. C. De cooman. Tempering kinetics of the martensitic phase in DP steel[J],ISIJ, 2006,46(1):138-146.[4] Takashi Furukawa, Mitsuru Tanino, Hirofumi Morikawa,etc. Effects of composition and processing factors on the mechanical properties of as-hot-rolled dual-phase steels[J],ISIJ,1984,24,113~121.[5] Wang Guo-dong, Liu Xiang-hua,Sun Li-gang,etc.Ultra fast cooling on Baotou CSP line and development of 590MPa grade C-Mn Low-Cost Hot-Rolled dual phase steel[J], Iron and steel,43(2),2008:49~52.chinese.[6] Liu Yan-chun,Dong Rui-feng,etc.Industrial trial of hot rolling dual phase C-Mn steel in a CSP line[J]. Steel rolling,2006,23(4):10~14.chinese[7] J.Neutjens, P.Harlet, T.Bakolas, etc.40th mech.working steel processing conf. proc., vol.XXXVI, ISS, Warrendale,PA,(1998),311.C-Mnsi[8] Sakir Bor A. Effect of pearlite banding on mechanical properties of hot rolled steel plates[J],ISIJ,Int,1991,31(2): 1445~1451. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%