为了降低热轧高强船板钢的拉力分层比率,对判定合格与不合格的拉伸残样进行了金相、扫描等对比检验,并且收集了所有试样对应钢板的生产工艺和技术参数,采用回归等统计分析方法得出造成拉力分层的根本原因是锰含量中心偏析,直接原因是裂纹与孔洞;利用回归方程预测,锰含量降低到1.30%以下时可以显著降低分层率。采取措施后拉力分层率由8.07%降低到1.25%,且可以稳定控制在2.0%以下。
In order to reduce the tensile test separation ratio,comparisons and inspection have been done between qualified and unqualified tensile test samples of hot rolled high strength hull plate with metallographic and SEM,and processing and technical parameters of each plate were gathered.With regression analysis and other statistical methods,we can know the direct reason causing the separation in tensile test sample is crack and hole which is caused by central manganese segregation.With regression analysis,we can know reducing the manganese content to 1.30% is an effective measure.The separation ratio can be reduced from 8.07% to 1.25%,and it also can be controlled steadily below 2.0% due to the lower manganese content.
参考文献
| [1] | 崔风平,赵乾,唐愈.铸坯内部缺陷对钢板分层形成的影响[J].中国冶金,2008(02):14-18. |
| [2] | 于建文,谭云松.钢板分层问题的探讨[J].锅炉制造,2001(01):45-47. |
| [3] | 国秀元,马兴云,杨宪礼,王学忠,李旺生.不同脱氧工艺对钢板分层的影响[J].炼钢,2001(06):38-42. |
| [4] | 高峰,海超,李媛媛,王立新.铁道车辆用09CuPTiRE耐候钢板分层的分析[J].特殊钢,2002(04):45-46. |
| [5] | 张乔英;刘国平;赵勇.低合金高强度钢板拉伸断口分层机理分析研究[A].北京:中国金属学会,2009:295. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%