利用共聚焦激光扫描显微镜原位观察了含硅低碳钢（0．98％硅）在三种不同冷速（1，10，30℃·s-1）下高温铁素体（δ）→奥氏体（γ）相变的过程，分析了冷速对该相变的影响。结果表明：随冷速的增加，过冷度增大，相变点下降；在慢冷速下，新相γ仅在δ晶界处形核，而在晶粒内部没有发现形核；在快冷速下，新相在晶界和晶粒内部形核，并且在晶粒内部形核需要更大的过冷度；新相γ在长大过程中是γ晶界以平面状迁移的方式“蚕食”δ母相。随冷速增加，晶界迁移速度增大。
High temperature ferrite （δ）→austenite （γ） phase transformation in a low carbon silicon-bearing steel （0. 98% Si） was observed by in situ using a confocal scanning laser microscope（CSLM） at three different cooling rates（1,10,30 ℃ · s-1）. The effect of cooling rate on the transformation was analyzed. The results show that the undercooling increased and the starting transformation temperature lowered with increasing the cooling rate. At lower cooling rate, the T phase nucleated only at the δ grain boundaries, but not happened inside the grains. While at higher cooling rate, the γ phase precipitated both at the δ grain boundaries and inside δ grains, and deeper undercooling was needed when inside the grains. The γ boundaries nibbled the δ matrix phase with plana-like patterns during its growth process. The migration velocity of the grain boundary increased with increasing the cooling rate.
参考文献
| [1] | 李长生,于永梅,汪水泽,石虎珍,王延溥.实验室薄板坯连铸连轧电工钢板的组织与性能[J].机械工程材料,2009(03):19-23. |
| [2] | 梁高飞,朱丽业,王成全,P.Nolli,吴建春,于艳,方园.AISI304不锈钢中δ→γ相变的原位观察[J].金属学报,2007(02):119-124. |
| [3] | 周磊磊,林大为,周灿栋,王成全,宋洪伟.不同冷却速度下双相不锈钢δ/γ相变过程的原位观察[J].上海金属,2007(03):19-23. |
| [4] | 方园,梁高飞,朱光明,王成全,吴建春,于艳.共焦激光扫描显微镜及其在钢铁相变原位观察中的应用[J].宝钢技术,2006(06):64-69. |
| [5] | Zhongzhu LIU;Yoshinao KOBAYASHI;Jian YANG;Kotobu NAGAI;Mamoru KUWABARA .'In-situ' Observation of the δ/γ Phase Transformation on the Surface of Low Carbon Steel Containing Phosphorus at Various Cooling Rates[J].ISIJ International,2006(6):847-853. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%