研究了Cu对00Cr25Ni7Mo4N双相不锈钢组织、力学性能、高温热塑性的影响.结果表明,Cu是非常弱的奥氏体形成元素,对扩大奥氏体相区没有明显的作用;加入1.5% 的Cu,可使00Cr25Ni7Mo4N钢固溶处理后的强度增加,冲击韧性降低,并降低了在900～1100℃固溶处理钢的断面收缩率,而在1150～1250℃温度范围固溶处理,两种钢的断面收缩率相近,均大于60%,热塑性较好.
参考文献
| [1] | Yasuhiro,MAEHARA .Superplastic deformation mechanism of α/γ duplex stainless steels[J].Transactions of the Iron and Steel Institute of Japan,1987,27:705-712. |
| [2] | Hutchinson W H;Ushioda K;Runnsj G .Anisotropy of tensile behavior in a duplex stainless steel sheet[J].Journal of Materials Science and Technology,1985,1:728-731. |
| [3] | Akihiko TAKAHASHI;Makio IINO .Microstructural Refinement by Cu Addition and Its Effect on Strengthening and Toughening of Sour Service Line Pipe Steels[J].ISIJ International,1996(2):241-245. |
| [4] | 吴玖.双相不锈钢[M].北京:冶金工业出版社,2000 |
| [5] | 宋维锡.金属学[M].北京:冶金工业出版社,1980 |
| [6] | 宋志刚,陈斌,郑文杰,王汉东,宗玉生.固溶温度对00Cr22Ni5Mo3N钢组织及力学性能的影响[J].钢铁研究学报,2004(06):47-50. |
| [7] | Naoyuki Sano;Yasuhiro Maehara .Initial Stage of Cu Precipitation in Cu-Added Ultra-low Carbon Steel[J].日本金属学会誌,1996(3):261-268. |
| [8] | 崔光洙,邸洪双,刘相华,王国栋.304HC不锈钢的热塑性及变形抗力的模型[J].东北大学学报(自然科学版),2001(06):656-659. |
| [9] | J. Y. Yoo;W. Y. CHOO;T. W. PARK .Microstructures and age hardening characteristics of direct quenched Cu bearing HSLA steel[J].ISIJ International,1995(8):1034-1040. |
| [10] | Yasuo Tsuchiya;Satoshi Hashimoto .Structure of Electrodeposited Zn-Mn Alloy Coatings[J].ISIJ International,2000(10):1024-1028. |
| [11] | Zhou G F;Wen M B;Li P H .Effect of copper and boron content on strain induced Nb(C,N) precipitation in ulcb steels at hot deformation temperature[J].Acta Metallurgica Sinica,2000,13(02):623. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%