利用有限元方法建立了刚性平面与多粗糙峰涂层的弹性接触模型,研究了刚性平面分别与二维涂层粗糙峰、三维涂层粗糙峰的接触状态,揭示了涂层/基体弹性模量比、涂层厚度、粗糙峰问距、刚性平面压下深度对涂层粗糙峰表面、涂层/基体界面等效应力分布及涂层基体变形的影响规律.计算结果表明:压下深度对涂层粗糙峰表面最大等效米塞斯应力的影响最大,涂层厚度和涂层/基体弹性模量比的影响次之,粗糙峰间距的影响最小;增大涂层厚度,减小压下深度、粗糙峰间距和低弹性模量比,会使得最大等效应力值显著降低.
参考文献
[1] | Ioannides E;Kuijpers J C .Elastic Stresses below Asperities in Lubricated Contacts[J].Journal of Tribology,Transactions of the ASME,1986,108:394-402. |
[2] | Komvopoulos K .Finite Element Analysis of a Layered Elastic Solid in Normal Contact with a Rigid Surface[J].Journal of Tribology,Transactions of the ASME,1988,110:477-485. |
[3] | Komvopoulos K;Choi D H .Elastic Finite Element Analysis of Multi-Asperity Contacts[J].Journal of Tribology,Transactions of the ASME,1992,114:823-831. |
[4] | L. Kogut;I. Etsion .Elastic-Plastic Contact Analysis of a Sphere and a Rigid Flat[J].Journal of Applied Mechanics,2002(5):657-662. |
[5] | Lin LP;Lin JF .A new method for elastic-plastic contact analysis of a deformable sphere and a rigid flat[J].Journal of Tribology,2006(2):221-229. |
[6] | Reedy J .Thin-coating Contact Mechanics with Adhesion[J].Journal of Materials Research,2006,21(10):2660-2668. |
[7] | 杨楠,陈大融,孔宪梅.多粗糙峰弹塑性接触的有限元分析[J].摩擦学学报,2000(03):202-206. |
[8] | 佟瑞庭,刘更,刘天祥.二维多粗糙峰涂层表面的弹塑性接触力学分析[J].机械科学与技术,2007(01):21-24. |
[9] | Geng Liu;Jun Zhu;Lie Yu;Q. Jane Wang .Elasto-plastic contact of rough surfaces[J].Tribology Transactions,2001(3):437-443. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%