铜基高强高导电材料的研究进展

机械工程材料, 2004, 28(9): 1-4. doi: 10.3969/j.issn.1000-3738.2004.09.001

铜基高强高导电材料的研究进展

陆德平 ^1, , 孙宝德 ^2, , 曾卫军 ^3, , 刘勇 ^4, , 张友亮 ^5, , 谢仕芳 ^6,

1.上海交通大学金属基复合材料国家重点实验室,上海,200030;江西省科学院应用物理研究所,江西,南昌,330029

2.上海交通大学金属基复合材料国家重点实验室,上海,200030

3.江西省科学院应用物理研究所,江西,南昌,330029

4.南昌大学机电工程学院,江西,南昌,330029

5.江西省科学院应用物理研究所,江西,南昌,330029

6.江西省科学院应用物理研究所,江西,南昌,330029

基金项目: 江西省科研项目(YP03-04)

关键词：铜 , 高强度 , 高导电

Research Progress of High-strength and High-conductivity Copper-based Materials

介绍了铜基高强高导电材料及用途,对这类材料常用的研究方法和制备技术进行了分析和综述,并展望了铜基高强高导电材料的发展趋势.

参考文献

[1]	曾汉民.高技术新材料要览[M].北京:中国科学技术出版社,1993:110.
[2]	黄崇祺.轮轨高速电气化铁路接触网用接触线的研究[J].中国铁道科学,2001(01):1-5.
[3]	王孟君.弥散强化铜电阻焊电极材料的研制[J].矿冶工程,2000(02):54.
[4]	张强.我国高速电气化铁路接触线与承力索的研制[J].电气化铁道,1997(02):9-14.
[5]	Ghosh G;Miyake J;Fine M E.The systems-based design of high-strength,high-conductivity alloys[J].Journal of The Minerals,Metals & Materials Society,1997:56-60.
[6]	龚寿鹏 .铜系合金引线框架材料的生产、发展和国产化[J].上海有色金属,1998,19(02):49-52.
[7]	Motohisa M .High-strength and high-conductivity alloy KLF201[J].Journal of the Japan Copper and Brass Research Association,1988,27:93-98.
[8]	Motohisa M .Performance of KFC-SH and KLF194-SHT copper alloys in high-strength and high-conductivity for lead fram[J].Journal of the Japan Copper and Brass Research Association,1990,29:224-233.
[9]	Hiroshi Y .Cu-Fe-Ti-Mg alloy used in electronic material[J].Journal of the Japan Copper and Brass Research Association,1984,23:109-115.
[10]	刘平;康布熙;曹兴国等.Zr和Mg对快速凝固Cu-Cr合金时效析出过程的影响[J].金属热处理学报,1999,20:46-50.
[11]	赵冬梅,董企铭,刘平,康布熙,金志浩.超高强度Cu-Ni-Si合金时效过程研究[J].材料热处理学报,2002(02):20-23.
[12]	卫英慧.Cu-Ti合金时效早期相变规律的研究[J].电子显微学报,1997(02):114.
[13]	Gao N.;Huttunen-Saarivirta E.;Tiainen T.;Hemmila M. .Influence of prior deformation on the age hardening of a phosphorus-containing Cu-0.61wt.%Cr alloy[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2003(1/2):270-278.
[14]	H. FERNEE;J. NAIRN;A. ATRENS .Cold worked Cu-Fe-Cr alloys[J].Journal of Materials Science,2001(22):5497-5510.
[15]	Tenwiek M J;Davies H A .Enhanced strength in high conductivity copper alloys[J].Materials Science and Engineering,1988,98:543-546.
[16]	Bell A;Davies H A .Solid solubility extension in Cu-V and Cu-Cr alloys produced by chill block melt-spinning[J].Materials Science and Engineering,1997,A226-228:1039-1041.
[17]	Juarez J A;Perez R;Albarran L A et al.Development of high-strength,high-conductivity copper alloys by rapid solidification[J].Journal of Materials Science Letters,1992,11:1104-1110.
[18]	Pantsyrnyi V.;Vorobieva A.;Khlebova N.;Potapenko I.;Silaev A.;Beliakov N.;Vedernikov G.;Kozlenkova N.;Drobishev V.;Shikov A. .High strength, high conductivity macro- and microcomposite winding wires for pulsed magnets[J].Physica, B. Condensed Matter,2001(0):669-673.

上一张下一张

计量

下载量()
访问量()

作者相关

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网

铜基高强高导电材料的研究进展

Research Progress of High-strength and High-conductivity Copper-based Materials

参考文献