欢迎登录材料期刊网

材料期刊网

高级检索

为了分析 PDP 列驱动芯片的能量恢复效率,提出了2种分析模型.DPLD(double-channel p-type lateral extended drain MOS)管是列驱动芯片中能量恢复电路的核心元器件.CRC(电容-电阻-电容)等效电路模型适用于漏电流能力较弱的 DPLD 管;VCCS(压控电流源)模型适用于漏电流能力较强的 DPLD 管;测试结果显示 CRC 和 VCCS 模型都具备较高的精度,模型误差分别是2.26%和4.04%.CRC 模型揭示了影响列驱动芯片能量恢复效率的因素有3个,分别是:充电时间、沟道电阻、负载电容.2种模型分析的对比结果表明,沟道电阻对列驱动芯片的能量恢复效率影响很大,使用较小沟道电阻的 DPLD 管可以显著提高 PDP 列驱动芯片的能量恢复效率.CRC 和 VCCS 模型可用于精确预测列驱动芯片的能量恢复效率.

Two analytical models are proposed to analyze the energy recovery efficiency of PDP data driver IC.DPLD (double-channel p-type lateral extended drain MOS)transistor is the key device of energy recovery circuit of data driver IC.CRC (Capacitor Resistor and Capacitor)equivalent circuit model is suitable for DPLD transistor which has poor drain current capacity.VCCS (Voltage Con-trolled Current Source)model is suitable for DPLD transistor which has strong drain current capacity. The test results reveal that both CRC and VCCS models have high precision,the model errors are 2.26% and 4.04%.CRC model reveals that the energy recovery efficiency of data driver IC is influ-enced by three factors,which are the charge time,channel resistor and load capacitor.The compared results of two models show that channel resistor has great influence on energy recovery efficiency of data driver IC.The energy recovery efficiency of PDP data driver IC can be improved significantly by using DPLD transistor which has smaller channel resistor.The proposed CRC and VCCS models can be used to predict the energy recovery efficiency accurately.

参考文献

[1] 卢海平;刘伟奇;康玉思.超大视场头盔显示光学系统设计[J].光学精密工程,201220(05):979-987.
[2] Kuei Y L;Paul C C.A new AMOLED pixel circuit with pulsed drive and reverse bias to alleviate OLED degrada-tion[J].IEEE Transactions on Electron Devices,201259(04):1123-1130.
[3] 常锋;孙志远;王瑞光.LED 显示图像的非均匀度校正改进方法[J].光学精密工程,201119(04):929-937.
[4] 王勇森;华国环;何晓莹.基于 PDP 驱动技术的行扫描芯片浪涌电压抑制方法[J].液晶与显示,201227(01):98-102.
[5] 冯庆志;王淑荣;王晓君.PDP 荧光粉的相对亮度与 VUV 激发光谱的测量[J].光学精密工程,200816(01):59-63.
[6] Value Electronics .Samsung,panasonic plasma TVs trounce the LED competition(Again)at flat panel shootout 2013[DB/OL].http://www.valueelectronics.com/,2013.
[7] Yeoul N;Seok J H;Junkyu M.A processor-based decoupled timing controller for flexible and low-cost 2D/3D plasma display panel design[J].IEEE TRANSACTIONS ON CONSUMER ELECTRONICS,201157(01):19-27.
[8] Xiao N Z;Chun L L;Zhen T T.Analysis of the address power in PDPs with a newly developed equivalent circuit model[J].IEEE TRANSACTIONS ON CONSUMER ELECTRONICS,200753(02):243-248.
[9] Jie L;Xiao Y H;Shen X.A review of energy recovery circuits for plasma display panels[J].IETE Techni-cal Review,201128(01):40-49.
[10] Sangshin K.A review of switch-mode sustain drivers with resonant networks for plasma display panels[J].IEEE Transactions on Industrial Electronics,201057(05):1624-1625.
[11] Sang K H;Myung J Y.High performance and low cost single switch current fed energy-recovery circuit for AC plasma display panel[J].IEEE Transactions on Power Electronics,200722(02):338-345.
[12] Sangshin K;Jin W J;Dong M L.A new sustain driver with energy recovery circuit based on low-voltage components and low-voltage power supply for AC plasma display panel[J].IEEE TRANSACTIONS ON CONSUMER ELECTRONICS,200854(03):1321-1328.
[13] Ling G M;Zhi H L;Chun L L.Energy recovery circuit with auxiliary power supply for AC plasma display panel[J].IEEE TRANSACTIONS ON CONSUMER ELECTRONICS,200753(02):765-768.
[14] Jae K P;Hyun L D;Bong H K.Asymmetric current buildup sustainer for AC plasma display panel[J].IEEE Transactions on Industrial Electronics,200855(04):1863-1870.
[15] Byong D C.Enhancement of current driving capability in data driver ics for plasma display panels[J].IEEE TRANSACTIONS ON CONSUMER ELECTRONICS,200955(03):992-997.
[16] Qian Q S;Sun W F;Li H S.Reliability investigations and improvements of the pLEDMOS for PDP data driver ICs[J].Semiconductor Science and Technology,201126(05):1-6.
[17] Behzad R.Design of Analog CMOS Integrated Circuit[M].Boston:McGraw-Hill,2001:23-24.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%