采用电弧离子镀方法在不锈钢基体上沉积Cr2O3薄膜.研究了氧流量和脉冲偏压对薄膜相结构、沉积速率、表面形貌、薄膜硬度的影响.结果表明,氧流量和脉冲偏压对薄膜的相结构有较大的影响.在氧流量为130 cm3/s、脉冲偏压为100V时,出现Cr2O3{001}面择优取向;氧流量增高,脉冲偏压增大时,薄膜的表面形貌得到改善;在脉冲偏压为-200 V、氧流量为130 cm3/s时,可获得符合Cr2O3化学计量比的薄膜,其硬度达到36 GPa.
参考文献
| [1] | Samsonov G V. The Oxide Handbook. 2nd ed., New York:IFI/Plenum, 1982: 192, 195 |
| [2] | Bhushan B, Theunissen G S A M , Li X D. Thin Solid Films, 1997; 311:67 |
| [3] | Zieren V, Jongh M D, Groenou A B V, Zon J B V,Lansinki P, Theunissen G S. IEEE Trans Magn, 1994; 30:340 |
| [4] | Zhang J L, Huang J, Ding C. J Them Spray Technol, 1998; 7:242 |
| [5] | Hones P , Levy F. J Mater Res, 1999; 14:3629 |
| [6] | Kao A S, Doerner M F, Novotny V J. J Appl Phys, 1989;66:5315 |
| [7] | Contoux G, Cosset F, Celerier A, Machet J. Thin Solid Films, 1997; 292:75 |
| [8] | Wang D Y, Lin J H, Ho W Y. Thin Solid Films, 1998; 332:295 |
| [9] | Bhushan B. Thin Solid Films, 1980; 3:255 |
| [10] | Bermudez V M, DeSisto W J. J Vac Sci Technol, 2001; 19:576 |
| [11] | Cheng C S, Gomi H, Sakata H. Phys Status Solidis, 1996; 155:417 |
| [12] | Abass A K, Jaboori E M. Phys Status Solidis, 1989; 116: K111 |
| [13] | Han L M. Plasma Heat Treatment. Tianjin: Tianjin University Press, 1997:178(韩立民.等离子热处理.天津:天津大学出版社,1997:178) |
| [14] | Hong M D. PhD Thesis, Dalian: Dalian University ofTechnology, 2002(黄美东.大连理工大学博士学位论文,2002) |
| [15] | Auciello O, Kelly R. Beam Modification of Materials 1Ion Bombardment Modification of Surfaces. Fundamentals and Application Amsterdam: Elservier Science Publishers, 1984:56 |
| [16] | Igasaki Y, Mitsuhashi H. Thin Solid Films, 1980; 70:17 |
| [17] | Hibbs M K, Hohansson B O, Sundgren J E, Helmersson U. Thin Solid Films, 1984; 122:115 |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%