为了实现Cu-P-Cr-Ni-Mo耐候钢的铁素体晶粒细化从而充分提高其强塑性,通过热模拟压缩试验,利用金相、SEM、EBSD等微观组织分析方法研究了其在双相区的多道次压缩变形过程中的组织演变.结果表明,试验钢在变形过程中,第二相(马氏体、贝氏体)呈条带状分布于铁素体基体上,随着道次增加,铁素体晶粒逐步细化,第5道次变形后得到1.8 μm左右的超细晶铁素体.前期铁素体晶粒细化的主要机制是形变强化铁素体相变,即多道次的累积大变形使组织内畸变能增大,铁素体形核点增多,促进铁索体快速析出,形成细小铁素体晶粒;后面几道次变形中,随着应变量继续增大,在铁素体晶粒内形成大量亚晶界,且亚晶界逐步累积扭转成大角度晶界,分割原来的粗大晶粒,发生铁素体连续动态再结晶细化.
参考文献
| [1] | ZHANG Chun-ling,CAI Da-yong,LIAO Bo,et al .Using Direct Hot-Rolling Approach to Obtain Dual-Phase Weathering Steel CuP-Cr-Ni-Mo[J].Journal of Materials Science,2010,45(2):490.,2010. |
| [2] | 张春玲,蔡大勇,廖波,赵田臣,樊云昌.09CuPCrNi耐候钢双相化的研究[J].钢铁,2004(03):50-53. |
| [3] | Tarigopula V,Hopperstad O S,Langseth M,et al .Elastic-Plastic Behaviour of Dual-Phase,High-Strength Steel Under Strain-Path Changes[J].European Journal of Mechanics A/Solids,2008,27(5):764.,2008. |
| [4] | Adamczyk J,Grajcar A .Structure and Mechanical Properties of DP-Type and TRIP-Type Sheets Obtained After the Thermomechanical Processing[J].Journal of Materials Processing Technology,2005,162(5):267.,2005. |
| [5] | Bleck W,Papaefthymiou S,Frehn A .Microstructure and Tensile Properties in Dual Phase and TRIP Steels[J].Steel Research International,2004,75(10):704.,2004. |
| [6] | Marion Calcagnotto,Yoshitaka Adachi,Dirk Ponge,et al .Deformation and Fracture Mechanisms in Fine and Ultmfine-Gmined Ferdte/Martensite Dual-Phase Steels and the Effect of Aging[J].Acta Materialia,2011,59(2):658.,2011. |
| [7] | Shin D H,Kim B C,Park T K .Microstructural Evolution in Commercial Low Carbon Steel by Equal Channel Angular Pressing[J].Acta Materialia,2000,48(9):2247.,2000. |
| [8] | 范爱琴,周乐育,邓陈虹,朱鲁曰.等通道转角挤压超细晶材料技术及其发展[J].钢铁研究学报,2012(07):1-4,28. |
| [9] | Hebesberger T,Stüwe H P,Vorhauer A .Strusture of Cu Deformed by High Pressure Torsion[J].Acta Materialia,2005,53 |
| [10] | Keisuke Nagato,Sumio Sugiyama,Akira Yanagida,et al .SinglePass Severe Plastic Formation of Ultrafine-Grained Plain Carbon Steel[J].Materials Science and Engineering:A,2008,478:376.,2008. |
| [11] | Seung Chan Hong,Kyung Sub Lee .Influence of Deformation Induced Ferrite Transformation on Grain Refinement of Dual Phase Steel[J].Materials Science and Engineering:A,2002,323:148.,2002. |
| [12] | 张西锋,袁守谦,魏颖娟.超细晶粒钢的制备原理及技术[J].钢铁研究学报,2008(04):1-7. |
| [13] | Eghbali B .EBSD Study on the Deformation of Fine Ferrite Grains in Plain Carbon Steel During Warm Deformation[J].Materials letters,2007,61(18):4006.,2007. |
| [14] | 王慧敏,杨忠民,车彦民.普通碳素钢超细晶微观组织的特征分析[J].钢铁研究学报,2006(10):45-48,62. |
| [15] | Han B Q,Yue S .Processing of Ultrafine Ferrite Steels[J].Journal of Materials Processing Technology,2003,136:100.,2003. |
| [16] | Huang Y D,Yang W Y,Sun Z Q .Formation of Ultrafine Grained Ferrite in Low Carbon Steel by Heavy Deformation in Femte or Dual Phase Region[J].Journal of Materials Processing Technology,2003,134(1):19.,2003. |
| [17] | 王占学,于淑娴,高有志,等 .16Mn钢(y→α)两相区控制轧制的研究[J].钢铁,1984,19(4):21.,1984. |
| [18] | 赵磊,郑为为,杨王玥,孙祖庆.Q235碳素钢多道次热变形中的组织演变及性能[J].北京科技大学学报,2004(05):507-511. |
| [19] | Molaei M J,Ekrami A .The Effect of Dynamic Strain Aging on Fatigue Properties of Dual Phase Steels With Different Martensite Morphology[J].Materials Science and Engineering:A,2009,527:235.,2009. |
| [20] | Steven Dillien,Marc Seefeldt,Sébastien Allain,et al .EBSD Study of the Substructure Development With Cold Deformation of Dual Phase Steel[J].Materials Science and Engineering:A,2010,527:947.,2010. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%