针对紫金山金铜矿低品位金矿石进行了常规颚式破碎机和高压辊磨机两种不同破碎方式下细粒级产品的全泥氰化浸出试验研究. 其结果表明:高压辊磨机较常规颚式破碎机产品粒度更细,-0 . 074 mm粒级产率高7 . 23 %;相同氰化浸出条件下,高压辊磨机( 8 . 5 MPa、13 . 5 MPa )-0. 15 mm的细粒级金浸出率能提高约2. 3 百分点和4. 5 百分点;进一步采用球磨机细磨至-0 . 074 mm达92 %后,目的金矿物基本单体解离,两种破碎方式对后续细磨后金浸出效果的影响相差不大;这也表明高压辊磨机对于略粗粒级产品的影响较大,对改善金矿石的浸出效果具有积极的促进作用.
Through the all-sliming cyanidation leaching experiments on fine-particle products of Zijinshan low-grade gold ore crushed by different comminution processes,influences of conventional jaw crusher and high pressure grinding rolls ( HPGR) have on the leaching rate of low grade gold ore were studied. The result shows that the prod-ucts of HPGR is finer than those of conventional jaw crusher,and the content of -0. 074 mm is about 7. 23% higher. At the same time,the gold leaching rate of -0. 15 mm fine particles by HPGR(8. 5 MPa、13. 5 MPa) under the same conditions can be increased by 2. 3 percentage points and 4. 5 percentage points. But with gold further grinded to-0. 074 mm above 92 %,the point where gold mineral is almost dissociated,the outcome of gold leaching rate from different comminution processes becomes similar. This also shows that HPGR has a bigger influence on coarse particle product and a positive effect on improving the leaching performance for gold ores.
参考文献
| [1] | Abdel-Zaher M. Abouzeid;Douglas W. Fuerstenau.Grinding of mineral mixtures in high-pressure grinding rolls[J].International Journal of Mineral Processing,20091(1):59-65. |
| [2] | 罗主平;刘建华.高压辊磨机在我国金属矿山的应用与前景展望（一）[J].现代矿业,2009(2):33-37,85. |
| [3] | 印万忠;侯英;丁亚卓;姚金;王余莲;罗溪梅;孙大勇.破碎方式对邦铺钼铜矿石可磨性及钼浮选的影响[J].金属矿山,2013(2):86-89. |
| [4] | D. Maxton;C. Morley;R. Bearman.A quantification of the benefits of high pressure rolls crushing in an operating environment[J].Minerals Engineering,20039(9):827-838. |
| [5] | F.P. van der Meer;W. Maphosa.High pressure grinding moving ahead in copper, iron, and gold processing[J].Journal Of The South African Institute Of Mining & Metallurgy,20127(7):637-647. |
| [6] | 刘建远;黄瑛彩.高压辊磨机在矿物加工领域的应用[J].金属矿山,2010(6):1-8. |
| [7] | Okay Altun;Hakan Benzer;Hakan Dundar;Namik A. Aydogan.Comparison of open and closed circuit HPGR application on dry grinding circuit performance[J].Minerals Engineering,20113/4(3/4):267-275. |
| [8] | 谢洪珍;胡杰华;阴菡.高压辊磨对矿石中金浸出影响试验研究[J].黄金科学技术,2013(5):145-148. |
| [9] | 何斌林;黄良伟.应用全泥氰化工艺提高金银回收率的研究[J].矿冶工程,2014(z1):216-217. |
| [10] | 谷晋川;刘亚川.金矿氰化浸出助浸出助浸剂的研究[J].金属矿山,2001(9):28-30. |
| [11] | 王燕民;潘志东.采用高压辊磨和搅拌磨湿法超细研磨的研究[J].过程工程学报,2006(z2):160-164. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%