The high grade non-oriented electrical steel sheets containing 3.0%Si were manufacturing processed using different cutting techniques, then they were stress relief annealed(SRA), the profiles and textures of the cutting edges were compared before and after annealing, and the magnetic properties of these specimens were tested and compared. The experimental results show that the iron loss of the specimen by water jet cutting is the lowest, but the magnetic induction under the low magnetic field is the highest, the iron loss of the specimen by laser cutting is the highest, but the magnetic induction under the low magnetic field is the lowest. It is necessary to adopt suitable production conditions and minimize the deterioration involved, and the magnetic property can be recovered by SRA effectively.
参考文献
| [1] | A. Schoppa;H. Louis;F. Pude .Influence of abrasive waterjet cutting on the magnetic properties of non-oriented electrical steels[J].Journal of Magnetism and Magnetic Materials,2003(0):370-372. |
| [2] | 黄力明,赵忻华.冲剪加工对冷轧硅钢片磁性能影响的试验研究[J].中小型电机,2004(03):10-13. |
| [3] | A. Belhadj;P. Baudouin;F. Breaban .Effect of laser cutting on microstructure and on magnetic properties of grain non-oriented electrical steels[J].Journal of Magnetism and Magnetic Materials,2003(1/3):20-31. |
| [4] | G. Loisos;A.J. Moses .Effect of mechanical and Nd:YAG laser cutting on magnetic flux distribution near the cut edge of non-oriented steels[J].Journal of Materials Processing Technology,2005(1/2):151-155. |
| [5] | M. Emura;F.J.G. Landgraf;W. Ross .The influence of cutting technique on the magnetic properties of electrical steels[J].Journal of Magnetism and Magnetic Materials,2003(0):358-360. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%