On the basis of theoretical analyses and calculations of high speed continuous impact force and tool notch surface temperature acted upon by burr and serrated chip edge, a notch wear model of low stress value and temperature impact fatigue was established. Saw-tooth-shaped burr and fin-shaped chip edge continuously impacts the rake face and flank face at high speed and high frequency, which results in a V-shaped notch wear. An experiment was done to validate that the saw-tooth-shaped burr does affect the notch wear. This model can be utilized to solve reasonably many problems that cannot be explained by any other theoretical assumptions.
参考文献
| [1] | I. A. Choudhury;M. A. El-Baradie .Machinability of nickel-base super alloys: a general review[J].Journal of Materials Processing Technology,1998(1/3):278-284. |
| [2] | E. O. Ezugwu;Z. M. Wang;A. R. Machado .The machinability of nickel-based alloys: a review[J].Journal of Materials Processing Technology,1999(1/3):1-16. |
| [3] | E. O. Ezugwu;J. Bonney;Y. Yamane .An overview of the machinability of aeroengine alloys[J].Journal of Materials Processing Technology,2003(2):233-253. |
| [4] | H. Z. Li;H. Zeng;X. Q. Chen .An experimental study of tool wear and cutting force variation in the end milling of Inconel 718 with coated carbide inserts[J].Journal of Materials Processing Technology,2006(1/3):296-304. |
| [5] | Deng Jianxin;Liu Lili;Liu Jianhua;Zhao Jinlong;Yang Xuefeng .Failure mechanisms of TiB{sub}2 particle and SiC whisker reinforced Al{sub}2O{sub}3 ceramic cutting tools when machining nickel-based alloys[J].International Journal of Machine Tools & Manufacture: Design, research and application,2005(12/13):1393-1401. |
| [6] | L. Li;N. He;M. Wang .High speed cutting of Inconel 718 with coated carbide and ceramic inserts[J].Journal of Materials Processing Technology,2002(1/3):127-130. |
| [7] | E.G. Ezugwu;J. Bonney;D.A. Fadare .Machining of nickel-base, Inconel 718, alloy with ceramic tools under finishing conditions with various coolant supply pressures[J].Journal of Materials Processing Technology,2005(0):609-614. |
| [8] | S. Lo Casto;E. Lo Valvo;E. Lucchini;S. Maschio;M. Piacentini;V. F. Ruisi .Ceramic materials wear mechanisms when cutting nickel-based alloys[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,1999(1):227-233. |
| [9] | Adrian Sharman;Richard;C. Dewes .Tool life when high speed ball nose end milling Inconel 718~(TM)[J].Journal of Materials Processing Technology,2001(1/3):29-35. |
| [10] | 肖茂华,何宁,李亮,刘海滨.陶瓷刀具高速切削镍基高温合金沟槽磨损试验研究[J].中国机械工程,2008(10):1188-1192. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%