材料期刊网

Projectiles of sintered tungsten alloy were fired directly at two kinds of steel target plates. The microstructures near the perforation of a medium, 0.45% carbon steel target plate can be identified along the radial direction as: melted and rapidly solidified layer, recrystallized fine-grained layer, deformed fine-grained layer, deformed layer and normal matrix. The adiabatic shear bands cannot be found in this intermediate strength steel. The microstructures along the radial direction of perforation of 30CrMnMo steel target plate are different from that of the medium carbon steel. There was a melted and rapidly solidified layer on the surface of the perforation, underneath there was a diffusing layer, and then fine-grained layer appeared as streamlines. Several kinds of adiabatic shear bands were found in this higher strength steel; they had different directions and widths, which were relative to the shock waves, as well as the complex deformation process of penetration. The deformation of the projectiles was rather different when they impacted on target plates of medium carbon steel and 30CrMnMo steel. The projectile that impacted on the medium carbon steel target plate was tamped and its energy dissipated slowly, while that which impacted on the 30CrMnMo steel target plate was sheared and the energy dissipated quickly.